Dust Bag Installation - Elektra Beckum Hobbymaster KS 250 Betriebsanleitung

4. Fit the table extension, on the left-hand side of
the saw, into the two outer holes – the offset
side of the table extension must point towards
the saw as shown.
5. Slide retaining bracket (arrow) from underside of
the saw over one of the two inner holes: the
holes in the retaining bracket and in the saw's
base must be lined up exactly.
6. Push table extension in, all the way to the stop.
7. Tighten screw on the retaining bracket.
8. Repeat step 4 to 7 on the saw's right-hand side
correspondingly.
9. Stand saw back on its feet.
Fence plate installation
· Screw fence plate to fence stop with thumb
screw as shown.
Work clamp installation
· Put the work clamp in one of the holes in the saw
base.
2.5
Fixing the saw
A
Risk of personal injury by rocking or tilt-
ing saw!
For a safe operation the saw must be fixed to
a sturdy base.
· A permanently mounted work plate or a work
bench can serve as a base.
· The saw can also – for mobile application – be
screwed to a plywood or wood-core plywood
sheet (800 mm x 800 mm, at least 19 mm thick).
When in use this plywood sheet must then be
secured with G-cramps to a work bench.
1. Drill four holes into the base.
2. Attach the saw with screws to the base.

Dust bag installation

A
Danger!
Dust of certain timber species (e.g. oak,
beech, and ash) can cause cancer when
inhaled:
- Work only with dust bag properly installed
or a dust collector connected (air speed at
the saw's dust spout ³ 20 m/s).
- Wear a dust mask in addition, as not all
saw dust is collected or extracted respec-
tively.
- Empty the dust bag regularly. Wear dust
mask when emptying.
· Put the dust bag onto the dust spout of the mitre
saw (ensure the dust bag's zipper is closed).
· Else connect a dust collector or industrial vac-
uum with a suitable adapter to the saw's dust
spout.
KS 250