Compound Mitre Cuts; Care And Maintenance; Saw Blade Change - Elektra Beckum Hobbymaster KS 250 Betriebsanleitung

Compound mitre cuts

3
A compound mitre cut is the combination of
mitre and bevel cut. Here the workpiece is cut
at an angle other the 90° across its width and
at the same time cut at an angle other than
90° vertical through its surface.
Starting position:
- Sawhead fully lifted
(if necessary, pull out locking pin);
- Set turntable to desired position.
- Tilt sawhead to desired bevel angle.
Execution:
The cutting operation is the same as described in
„standard cross cuts".

Care and maintenance

A
Danger!
Prior to all servicing:
- Switch machine OFF.
- Unplug power cable.
- Wait until the saw has come to a complete
stop.
· Check that all safety devices are operational
again after each service.
· Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equipment
maker can cause unforeseen damage.
· Repair and maintenance work other than
described in this section should only be carried
out by qualified specialists.

Saw blade change

A
Danger!
Directly after cutting the saw blade may be
very hot – risk of burns! Let a hot saw blade
cool down. Do not clean the saw blade with
combustible liquids.
Risk of injury, even with the blade at stand-
still. Wear gloves when changing blades.
On re-assembly observe direction of rotation
of inner blade collar, saw blade and outer
blade collar!
KS 250
1. Unscrew the three screws (A), (B) and (C) on
the saw blade guard and remove the saw blade
guard.
C
B
A
2. To lock the saw blade in position, depress the
lock knob and turn the saw blade with your other
hand until the lock engages.
3. Loosen arbor bolt with box wrench (left-hand
thread!).
4. Remove from the saw blade shaft:
- arbor bolt,
- washer,
- outer blade collar,
- saw blade and
- inner blade collar
5. Clean clamping surfaces of:
- saw spindle,
- saw blade,
- outer blade collar,
- inner blade collar.
2.8