Mitre Cuts; Bevel Cuts - Metabo KGS 303 PLUS Originalbetriebsanleitung

Cutting the work piece:
1. Hold workpiece against the fence.
2. Push the safety lock to the side and
press and hold the ON/OFF switch.
3. Slowly swing the sawhead fully
down, holding the handle firmly.
When sawing, exert only moderate
pressure to prevent the motor speed
to drop too much.
4. For wider workpieces pull the saw-
head forward (towards the opera-
tor).
5. Cut workpiece in a single pass.
6. Release the ON/OFF switch and let
the sawhead slowly return to its
upper starting position.
8.2

Mitre cuts

3 Note:
A mitre cut cuts the workpiece at
an angle against the rear guide edge.
Maximum workpiece cross
(dimensions in mm):
15°
22.5°
30°
45°
50°
60°
right
Starting position:
− Sawhead fully raised.
− Cutting depth limiter set to maxi-
mum depth of cut.
− Motorhead in vertical (90°) position,
bevel tilt locking lever tightened.
− Hinged fence on top of the fence
and secured.
− Track arm not extended.
− Locking screw of the track arm loos-
ened.
Cutting the work piece:
Loosen the locking screw (51) of the
1.
rotating table (50).
2. Set to desired angle.
3
Note:
The rotating table engages at
positive stops at the 0°, 15°, 22.5°, 30°,
45°, and 60° position.
3. Tighten the rotating table's locking
screw.
4. Cut workpiece as detailed under
"Standard cross cuts".
8.3

Bevel Cuts

3
Note:
A bevel cut cuts the workpiece at
an angle other than 90° against its sur-
section
face.
Width Height
approx. approx.
288 81
275 81
257 81
210 81
190 81
148 81
50 51
ENGLISH
Maximum workpiece cross
(dimensions in mm):
Width
approx.
22.5° 300
left
22.5 ° 300
right
45 ° 300
left
45 ° 300
right
48 ° 300
left
48 ° 300
right
Starting position:
− Sawhead fully raised.
− Cutting depth limiter set to maxi-
mum depth of cut.
− Rotating table in 0° position, the
locking screw of the rotating table is
tightened.
− Track arm not extended.
− Locking screw of the track arm loos-
ened.
Cutting the work piece:
1. If the sawhead is to be tilted
between 22.5 ° and 48° to the right,
swing the hinged fence down.
Loosen the ratchet lock lever (52)
2.
for sawhead tilt at the rear of the
saw.
52
section
Height
approx.
70
65
50
25
45
20
23