Available Saw Blades - Metabo KGS 303 PLUS Originalbetriebsanleitung

Voltage
Noise emission according to DIN EN 61029-1 **
Sound power level L
WA
Sound pressure level at operator ear L
Effective value of weighted acceleration (Vibration at handle)
Uncertainty K
Dust collector (not included in standard delivery)
− Suction port diameter
− Minimum air volume flow
− Minimum vacuum at suction port
− Minimum air speed at suction port
* This machine is specially designed for the high momentary loads of crosscutting. The motor reaches the stated power of
1800 watts at S6 20% 5 min. (intermittend periodic duty-type with starting). This means that this saw can be operated for 1 minute
at full-load rating (1800 watts) within a 5 minute operating period. The motor has to deliver these 1800 watts only under extreme
load conditions - during normal crosscutting it is subjected to much lower loads. With lower loads the duty cycle of the motor
increases substancially. Thus, when used as specified, because of its high reserve capacity, overheating or overloading of the
motor is not possible.
** The values stated are emission values and as such do not necessarily constitute values which are safe for the workplace.
Although there is a correlation between emission levels and environmental impact levels, whether further precautions are neces-
sary cannot be derived from this. Factors influencing the actually present environmental impact level in the workplace include the
characteristics of the work area and other noise sources, i.e. the number of machines and other neighbouring work processes. Also,
permissible workplace values may vary from country to country. This information is intended to assist the user in his estimate of
hazards and risks.

15.1 Available saw blades

Diameter
250 mm
250 mm
250 mm
250 mm
PA
Arbor bore Tooth rake
30 mm 5° neg.
30 mm 5° neg.
30 mm 5° neg.
30 mm 6 ° neg.
V
dB (A)
dB (A)
2
m/s
2
m/s
mm
3
m /h
Pa
m/s
No. of teeth
24
alternate top bevel non-lamintated
teeth particle board
48
alternate top bevel
teeth
60
alternate top bevel
teeth thick-walled plas-
tic extrusions
80
trapezoidal-flat
teeth Cable ducting,
NF profiles,
high-quality
veneered sheets,
ENGLISH
230 (1∼ 50 Hz) 110 (1∼ 50 Hz)
118
104
< 2.5 < 2.5
1.5
35
550
740
20
Used for Stock-no.
wood, 628 013 000
wood, 628 047 000
panels
wood, 628 048 000
panels
wood, 628 088 000
panels
laminates
118
104
1.5
35
550
740
20
29