Environmental Protection; Trouble Shooting; Technical Specifications - Metabo KGS 303 PLUS Originalbetriebsanleitung

ENGLISH

13. Environmental Protection

The machine's packing can be 100%
recycled.
Worn out power tools and accessories
contain considerable amounts of valua-
ble raw and rubber materials, which can
be recycled.
These instructions are printed on paper
produced with elemental chlorine-free
bleaching process.

14. Trouble Shooting

This section describes problems and
malfunctions which you should be able
to resolve yourself. If the measures
detailed here do not solve your problem,
see under "Repairs".
A
Danger!
Many accidents happen particularly
in connection with problems and
faults. Therefore please note:

15. Technical specifications

Voltage
Current draw
Fuse protection
Motor capacity*(power input P1, S6 20% - 5 min)
Protection class
Degree of protection
Saw blade speed
Cutting speed
Saw blade diameter (outer)
Arbor bore
Dimensions
Machine in packing
− Length / width / height
Machine ready to work, rotating table in 90°position, c/w suction port
− Length / width / height
Maximum workpiece cross section
Standard cross cuts
− width / height
Mitre cuts (rotating table 45°)
− width / height
Bevel cutss (track arm holder 45° left)
− width / height
Compound mitre cuts (rotating table 45° / sawhead 48 ° left)
− width / height
Weight
Machine in packing
Machine ready to work
Permissible ambient temperature for operation
Permissible temperature for transport and storage
28
•
Always unplug before servicing.
•
Check that all safety devices are
operational again after each fault
service.
Motor does not run
No mains voltage
•
Check cables, plug, outlet and
mains fuse.
No crosscut function
Transport locking pin engaged:
•
Pull transport locking pin out.
Safety lock engaged:
•
Actuate the safety lock.
Only little sawing performance
Saw blade blunt (possibly tempering
marks on blade body):
Saw blade not suitable for material being
cut (see chapter "Technical specifica-
tions");
Saw blade warped:
•
Replace saw blade (see chapter
"Maintenance").
Saw vibrates heavily
Saw blade warped:
•
Replace saw blade (see chapter
"Maintenance").
Saw blade incorrectly mounted:
•
Mount saw blade correctly (see
chapter "Maintenance").
Saw squeals when starting
Drive belt tension too low:
•
Retension the drive belt (see chap-
ter "Maintenance - Drive belt ten-
sioning").
Stiffness of rotating table
Saw dust build-up under rotating table:
•
Remove saw dust.
V 230 (1∼ 50 Hz)
A 8.4
A 10 (time-lag)
kW 1.8
IP 20
II
-1
min 5020
m/s 66
mm 250
mm 30
mm 800 / 600 / 450
mm 575 / 900 / 595
mm 300 / 81
mm 210 / 81
mm 300 / 50
mm 210 / 45
kg 26
kg 20
°C
0 to + 40
°C
0 to + 40
110 (1∼ 50 Hz)
15.9
-
1.6
20
II
5020
66
250
30
800 / 600 / 450
575 / 900 / 595
300 / 81
210 / 81
300 / 50
210 / 45
26
20
0 to + 40
0 to + 40