Inhaltsverzeichnis
Werbung
9) ADJUST THE ANGLE OF THE HANDLE
9.1 Adjust the angle of the handlebar by
pressing the grey buttons on the inside of the
handlebar. Keep the buttons pressed and
adjust to the desired position. Make sure they
click into position.
WARNING
Ensure that children are kept away
from all moving parts of the pram to avoid risk
of injury.
10) ADJUSTING THE TELESCOPIC HANDLE
10.1 Open both clips on the handle bar and
adjust to the desired position. Lock both grey
clips on both sides of the handlebar. Make sure
that the telescopic handlebar is properly locked
with a "click".
Make sure that the handlebar is at the same
height on both sides before you lock into place.
11) THE FRONT WHEELS CAN BE FIXED OR
ROTATED 360 DEGREES.
11.1 The wheels can be locked by pressing the
locking ring when the wheels are in the "forward
facing" position. The wheels can rotate freely
through 360 degrees when the locking wheel is
released.
WARNING Ensure that children are kept away
from all moving parts of the pram to avoid risk
of injury.
WARNING
11.2
Never pull the pram when
the swivel wheels are unlocked. The pram may
wobble which can lead to a safety risk if you are
not cautious and careful.
11.3 The front wheels can be locked in a forward
position.WARNING
wheels shall only be used when the pram is
parked. Never push the pram with the wheels
locked in forward position.
12 )ASSEMBLY OF THE BASKET
1.1 Fasten the 3 buttons on the back around the
tube
1.2 - 1.3 Pull the knobs through the holes
CARRYCOT
1) ASSEMBLY OF THE CARRYCOT
1:1 To erect the carrycot pull the bar using
the easy pull handle along the bottom of the
carrycot towards the plastic stops. Repeat both
in the foot end and the head end.
WARNING Make sure the metal bars are firmly
attached to the carrycot frame before the
carrycot is erected. If the metal bars are not in
place, the fabric may be damaged.
46
This position of the front
1.2 Remove the mattress from the plastic bag
(discard safely)
WARNING
Do not use additional mattresses in
the carrycot. Use only the Emmaljunga original
mattress that comes with the pram.
WARNING
Risk of suffocation. Do not let
children play with plastic bags.
1.3 Press both buttons on the inside of the hood
and pull it up.Attach the apron using the velcro
straps on each side of the carrycot.
The hood can be folded up and down in the
desired position by pressing both buttons on
the inside of the hood.
1.4 The hood is attached to the carrycot with
velcro strips.
1.5 For ventilation, open up the Velcro strap on
the hood. You can fasten the hood in place by
folding under and securing it with the press stud
on the inside of the hood.
The ventilation and UV/Insect net on the back of
the hood is now visible. (only on certain models)
2) ATTACH THE CARRYCOT
2:1 Put on the brake. Lift the carrycot with the
handle and place it onto the frame. Press down
so that the carrycot locks into place you will hear
a "click" on both sides.
WARNING
Always check that the carrycot is
properly attached in the locked position on
both sides.
WARNING
2:2
Never use the carrycot in the
position with the hood placed towards the
handlebar (see picture).
The hood on the carrycot should always be
placed away from the handlebar
3) REMOVE THE CARRYCOT
3:1 Put on the brake. Under the carrycot base,
push in the button and pull the handle towards
you. Lift the carrycot upwards.
WARNING
Always check that the carrycot is
properly secured in the locked position on both
sides.
WARNING
3:2
Always use the carrycot lifting
handle as illustrated. This is very important!
WARNING
Never leave the carrycot near the
stairs, on the top of a table or in places where it
can fall off.
WARNING
Do not use the carrycot as a cradle
outdoors or on uneven surfaces.
WARNING
Do not use the carrycot as a bed for
your child.
WARNING
3:3
Never lift the carrycot with
the lifting handle as illustrated. This is very
important!
NXT SELECT V1.2
Werbung
Inhaltsverzeichnis
