Maintenance; To Clean The Base Unit; To Clean The Filter; To Clean The Spray Head Nozzle - Meec Tools 009875 Bedienungsanleitung

3
Turn the power switch to the "OFF/0" position to stop
the product. (Figure 10)
Warning! There is still pressure in the system after
you have stopped the product.
5

Maintenance

5.1 To clean the base unit

Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
Warning! Do not immerse the product in water or
other liquid. Risk of electrical shock.
● Clean the base unit with a damp cloth.

5.2 To clean the filter

Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
1
Stop the product. Refer to "4.7 To change spray mode"
on page 37.
2
Disconnect the water hose from the water inlet on
the product.
3
Carefully pull out the filter in the water inlet. Use
flat-nose pliers.
4
Rinse the filter in clean hot water. (Figure 14)
5
Install the filter in the water inlet.

5.3 To clean the spray head nozzle

Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
1
Stop the product. Refer to "4.7 To change spray mode"
on page 37.
2
Remove the spray head from the spray gun.
3
Use the nozzle cleaning tool (included with the
product) to remove unwanted materials from the
nozzle on the spray head. (Figure 15)
2022_001
4
Rinse the nozzle on the spray head.
6

Transport

6.1 To transport the product by hand

Warning! Be aware of the weight of the product. Be
careful when you move the product.
1
Stop the product. Refer to "4.7 To change spray mode"
on page 37.
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Disconnect the water hose from the water inlet on
the product.
4
Push in the release button for the transport handle
and pull up the transport handle until you hear a click
sound.
Note! Use transport protection if it is necessary.
5
Hold the transport handle and tilt the product until it
balances on its wheels to move the product.
6.2 To transport the product with a
vehicle
Warning! Be aware of the weight of the product. Be
careful when you move the product.
1
Stop the product. Refer to "4.7 To change spray mode"
on page 37.
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Disconnect the water hose from the water inlet on
the product.
4
Make sure that the lid on the detergent container is
installed.
5
Make sure that product cannot move around in or on
the vehicle when you transport the product.
Caution! Vibrations and shocks can cause damage to
the product. Use applicable transport protection when you
transport the product with a vehicle.
38