Safety Devices On The Product; Assembly; To Assemble The Product - Meec Tools 009875 Bedienungsanleitung

● Do not disassemble the product. The manufacturer
cannot accept liability for any damage that is a result of
unauthorized disassembly.
● Do not let children operate the product.
● Do not let persons with physical, sensorial or mental
disabilities operate the product without training or
supervision.
● Do not let persons who do not have the required
experience, knowledge or training operate the product
without training or supervision.
● Do not let children play with the product.
● Keep the packaging material away from children. Risk of
suffocation.
● Only use accessories and parts that are approved by the
manufacturer of the product.
● Only use chemicals that are recommended by the
manufacturer of the product.
● Do not use the product with flammable liquids. Risk of
explosion.
● Do not drink water that has been used with the product.
● Do not bend or clench the high-pressure hose. The
reinforcement in the high-pressure hose can become
damaged.
● Keep the high-pressure hose away from hot surfaces, oil
and sharp edges.
● Put the high-pressure hose so that it cannot be driven
over, stepped on, or tripped over.
● Only connect the product to a power outlet that is
correctly earthed. Speak to an authorized electrician if
you are not sure.
● Make sure that the mains voltage corresponds to the
rated voltage on the type plate of the product. Speak to
an authorized electrician if you are not sure.
● Make sure that the product is connected to the mains
supply with a residual current device with a maximum
tripping current of 30 mA. Speak to an authorized
electrician if you are not sure.
● Speak to an authorized electrician it the power plug does
not fit in the power outlet. Do not modify the power plug.
● Electrical connections must only be carried out by an
authorized electrician. Electrical connections must
comply with IEC60364-1.
● Put the power cord so that it cannot be driven over,
stepped on, or tripped over.
35
● Keep the power cord away from hot surfaces, oil and
sharp edges.
● Do not use the power cord to carry the product.
● Do not use the power cord to pull the power plug from
the power outlet.
● Only use approved extension cords that are specified in
this manual.
● Do not put any electrical connections directly on the
ground or floor. Electrical connections must be kept dry
and at least 60 mm above the ground or floor.
● Always pull out the complete extension cord.
● Do not go away from the product when it is in operation.
● Disconnect the product from the power outlet when it is
not in operation.
● Do not keep detergent in the product when it is not in
operation. Keep detergents away from children. Follow
the safety instructions from the manufacturer of the
detergent.
● Always stop the product, disconnect the power plug, and
release the pressure in the system before you clean or do
maintenance on the product.
● Keep the product in a dry and closed storage, away from
children, when the product is not in operation.
● Clean the product regularly.

2.3 Safety devices on the product

The product has the safety devices that follow.
● Overpressure valve
● Trigger lockout
● Overheat protection
3

Assembly

3.1 To assemble the product

1
Install the transport handle with the 4 screws.
(Figure 2)
2
Install the spray gun holder on the right side of the
transport handle. (Figure 3)
3
Install the power cord holder on the left side of the
transport handle. (Figure 4)
4
Install the 2 wheels. (Figure 5)
2022_001