To Disengage And Engage The Trigger Lockout; To Remove Air From The System; To Operate The Product; To Change Spray Mode - Meec Tools 009875 Bedienungsanleitung

4.4 To disengage and engage the
trigger lockout
The trigger can be locked to prevent accidental operation of
the spray gun.
● Push the trigger lockout button to the locked position (A)
to engage the trigger lockout. (Figure 12)
● Push the trigger lockout button to the unlocked position
(B) to disengage the trigger lockout.

4.5 To remove air from the system

Warning! Use safety glasses and applicable personal
safety equipment.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Caution! Only operate the product in an upright
position on a level and stable surface. (Figure 11)
1
Start the product. Refer to "4.3 To start the product"
on page 36.
2
Remove the spray gun from the spray gun holder.
3
Disengage the trigger lockout. Refer to "4.4 To
disengage and engage the trigger lockout" on page
37.
4
Hold the spray gun firmly with both hands and push
in the trigger. Water starts to come out from the spray
head. Keep the trigger pushed in until water without
air bubbles comes out of the spray head.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Caution! Do not operate the product for more than
2 minutes without water. The high-pressure pump can be-
come damaged if you operate the product without water.
5
Release the trigger and engage the trigger lockout.
6
Turn the power switch to the "OFF/0" position.
(Figure 10)
37

4.6 To operate the product

Warning! Use safety glasses and applicable personal
safety equipment.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Warning! Always engage the trigger lockout before
you take a pause from operation.
Warning! Always turn the power switch to the
"OFF/0" position if you are away from the product for more
than 5 minutes.
1
Start the product. Refer to "4.3 To start the product"
on page 36.
2
Point the spray gun at the surface you want to clean.
3
Disengage the trigger lockout. Refer to "4.4 To
disengage and engage the trigger lockout" on page
37.
4
Hold the spray gun firmly with both hands and push
in the trigger. Keep the trigger pushed in and move
the spray head over the surface until the surface is
clean.
Caution! Hold the nozzle of the spray head at least
30 cm away from painted surfaces when you operate the
product.
Note! The spray gun operates until you release the trigger.

4.7 To change spray mode

The spray head has 3 spray modes, fan shape mode (A), line
shape mode (B), and foam mode (C). (Figure 16)
● To change spray mode, turn the top of the spray head
until the arrow is at the required mode.

4.8 To stop the product

1
Release the trigger on the spray gun and engage the
trigger lockout. Refer to "4.4 To disengage and
engage the trigger lockout" on page 37.
2
Put the spray gun in the spray gun holder.
2022_001