Personal Safety; Personnel Requirements - Bluetti EP500 Bedienungsanleitung

2.1.1. Personal Safety

• During the operation of the equipment, if a malfunction that may cause personal
injury or equipment damage is found, it should be powered off immediately.
• Please do not power on the device if the device has not been properly installed
or confirmed by all relevant personnel.

2.1.2. Personnel Requirements

• The personnel responsible for the installation and maintenance of the
equipment must first undergo rigorous training to understand various safety
precautions and be able to grasp the correct method of operation.
• Trained personnel are personnel who have undergone corresponding technical
training and have the necessary experience to be aware of the dangers that are
present during the operation of the unit and can take measures to reduce the
dangers to him or herself and upon others.
• The replacement of equipment or parts (including software) must be done by
professionals or by authorized personnel only.
2.1.3. Anti-static requirements
When installing the sub-panel with your main panel, you must wear anti-static
gloves or an anti-static wrist strap before touching the device. The other end of
the anti-static wrist strap should be properly grounded. Do not touch any bare
components directly with your hands.
2.1.4. Drilling
The following safety precautions are to be considered when drilling holes on the
wall or into the ground:
• It is strictly forbidden to drill holes into the equipment. Drilling will alter and
damage the electromagnetic shielding performance of the equipment, internal
components, and possibly cables. The risk of metal shavings entering the device
can cause short circuits.
• Wear goggles and protective gloves when drilling holes.
• The equipment should be shielded and protected during the drilling process to
prevent debris from falling into the equipment. After drilling, any and all debris
which may have landed on the equipment should be removed and cleaned in a
timely manner.
EN-04
BLUETTI