General Safety Instructions - Bluetti EP500 Bedienungsanleitung

1.2. Abbreviation
• BMS: Battery Management System
• MPPT: Maximum Power Point Tracking
• UPS: Uninterruptible Power Supply
• AC: Alternating Current
• DC: Direct Current
• PV: Solar Panel(s) Charging (Photovoltaic)
• Grid: Home Power Supplied by Utility
• T500: 500W Additional Adapter
• DOD: Depth of Discharge
• ECO Mode: A power saving mode for the EP500. In this mode, the AC output
ports are automatically turned off if the load is less than 20W over a span of 4
hours.

02. General Safety Instructions

Please read this manual before operating.
• A licensed electrician is required to install the grid-tied power system as it
involves connecting the wires of critical loads from your main electrical box to
the BLUETTI Sub Panel (Optional Purchase).
• DO NOT place the power station near heat sources. It is prohibited to place the
equipment in an environment with flammable, explosive gas, or smoke. It is also
prohibited to operate the equipment in this environment.
• DO NOT attempt to replace the internal battery or any other component of the
equipment by anyone other than authorized personnel. There are no enduser
serviceable components.
• DO NOT operate in wet conditions. If the equipment becomes wet, please let the
unit dry completely before using.
• Please ensure proper ventilation while in use and do not obstruct fan openings.
Inadequate ventilation may cause permanent damage to the equipment.
• DO NOT stack anything on top of the power station while in storage or while in
use. DO NOT move the unit while operating as vibrations and sudden impacts
EN-02
BLUETTI