Bluetti EP500 Bedienungsanleitung Seite 40

Just Power On
037 NTC Error
038 Calibration
Inverter Over-load
039
Protection
Inverter Output Short
040
Circuit
041 Network Address Error
Network Communication
042
Error
043 Grid Phase Failure
044 Network Sync Error
045 PFC Error
046 Grid Input Over Current
049 SPI Communication Error
050 BMS Communication Error
051 EEPROM Read_write Error
DSP Parameter
052
Misconfiguration
057 BMS Temperature Error
Please leave the unit at the recommended
temperature few hours to recover.
Please contact with the dealer if the error still exists
after rebooting the unit.
Please contact with the dealer if the error still exists
after rebooting the unit.
Please disconnect the load to make sure the output
power of loads meet the limit of the unit.
Click to clear the alarm history.
Please disconnect the load to make sure the load has
been connected properly.
Click to clear the alarm history.
Please reset the "Master"unit or "Slave"unit. Click to
clear the alarm history or reboot the unit.
Reconnect the communication wire again.
Please reset the "Master"unit or "Slave"unit.
Click to clear the alarm history or reboot the unit.
Check the input wire and whether the" Master" unit
or "Slave"unit can work well.
Reconnect the communication wire again.
Please reset the "Master"unit or "Slave"unit.
Click to clear the alarm history or reboot the unit.
Check whether the grid works well.
Please contact with the dealer if the error still exists
after rebooting the unit.
Check whether the EP500 is on.
Disconnect the loads on the grid or EP500.
Check whether the Max. Grid input current could
work well with strips or your Air Breaker.
Please contact with the dealer if the error still
exists after rebooting the unit.
Please contact with the dealer if the error still exists
after rebooting the unit.
Please reset the configurations on "Settings".
Please contact with the dealer if EP500 have not
been recovered after rebooting.
Please reset the configurations on "Settings".
Please contact with the dealer if EP500 have not
been recovered after rebooting.
Please store EP500 at the recommended
temperature and leave it until the temperature inside
back to the normal standard.
EN-37