Bluetti EP500 Bedienungsanleitung Seite 33

PV Priority Mode which allows the EP500 to charge to 100% from either or both
grid & solar (PV).
10.2.3. Time Control UPS
• This allows you to set the times that EP500 will be charged via grid power and
the times to run loads from its battery.
Charge Time: Set the time of EP500 when to be charged by grid to avoid the
higher time-of-use electricity (peak) rates, normally set to off-peak times.
Discharge Time: Set the time to use the EP500 batteries to power the loads
connected on AC output port of EP500 or Sub Panel (Optional Purchase). Usually
set during peak-rate hours.
• Parameter Setting:
Battery SOC Low: When the remaining capacity of EP500 is under the preset
Battery SOC Low state, the EP500 will stop powering loads connected to the AC
output ports of the EP500 or Sub Panel (Optional Purchase).
Battery SOC High: The maximum capacity EP500 can be charged via grid. The
remaining percentage will be charged either by solar (PV) or 2nd adapter.
EN-30
BLUETTI