eQ-3 homematic IP HmIP-eTRV-CL Montage- Und Bedienungsanleitung Seite 59

6.8 Direct pairing
To pair the radiator thermostat directly with another Homematic IP de-
vice, you can activate the pairing mode for direct pairing as follows:
Press and hold the menu button (D) for approx. 2 seconds to
•
open the configuration menu.
• Select "PAIR" using the plus and minus buttons (C + E) and con-
firm with the menu button.
• Fast orange flashing indicates the pairing mode is activated.
6.9 Pairing with the access point
To pair the radiator thermostat with a Homematic IP Access Point, you
can activate the pairing mode as follows:
Press and hold the menu button (D) for approx. 2 seconds to
•
open the configuration menu.
Select "INCL" using the plus and minus buttons (C + E) and con-
•
firm with the menu button.
• The menu item flashes to indicate that the pairing mode is acti-
vated.
6.10 Restoring factory settings
The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
• Press and hold the menu button (D) for approx. 2 seconds to
open the configuration menu.
Select "RES" using the plus and minus buttons (C + E) and confirm
•
with the menu button.
Press and hold the menu button until the device LED (D) starts to
•
quickly flash orange.
• Briefly release the menu button then press and hold the menu
button again until the orange flashing changes to a steady green
light.
• Release the menu button again to finish restoring the factory set-
tings. The device will perform a restart.
Configuration menu
59