Monacor PA-1200IRD Einbau- Und Bedienungsanleitung Seite 32

connection to the network will be discon-
nected when it is not required, e. g. during
FM reception or in the standby mode (will
save power). Either confirm
and confirm.
Note: When operating the module without any
network connection (as described in step 6A), it is
recommended to select
5) The following message will briefly appear:
Please select Wlan re g ion
Then, a regional selection for the network
setting will appear:
Wlan re g ion
Europe
Australia
The line
Europe
lection when the country where the module
is operated is in Europe.
6) The scan for a network will start:
Network settin g s
Network wizard
Scannin g /
The menu with a list of all networks found
will appear:
SSID
[WPS]Cafeteria-1
TechDocu
[Rescan]
[Wired]
[Manual confi g ]
A For operation without a network con-
nection:
Press the button MENU and answer the
confirmation prompt
at next start up?
ule can now be used for all functions not
requiring a network connection.
B For connection to the network via
cable (LAN):
Select
[Wired]
tion. The connection to the network will
be established: continue with step 8.
32
YES or select
.
NO
⑭
is marked. Confirm this se-
⑮
⑯
Run wizard a g ain
as desired. The mod-
and confirm your selec-
C For wireless connection to the net-
work (WLAN):
Select the name of your network (SSID)
NO and confirm your selection. If access to
your network is not encrypted, the con-
nection to the network will be established:
continue with step 8. If access to your net-
work is encrypted, continue with step 7.
Note:
[WPS]
the router supports WPS.
D As an alternative to the methods described
in B and C, manual configuration can
be selected (e. g. if the network name is
not visible or the DHCP function is not
available).
Note: Manual configuration requires knowl-
edge of network technology.
a) Select
your selection.
b) Select
on the connection type of the module
and confirm.
c) In the next menu, select
and confirm if the router automatically
transmits the network settings to the
module via DHCP. If the DHCP function
on the router has been deactivated or
is not available, select
confirm and make the settings for IP ad-
dress, subnet mask, gateway address
and DNS in the menus that follow.
In case of cable connection to the net-
work, the network connection will be
established when the last setting has
been confirmed, continue with step 8.
In case of wireless connection, continue
with step d.
d) The menu for entering the network
name will appear:
SSID
0123456789._- ,
abcdefghijklmn
opqrstuvwxyzABC
DEFGHIJKLMNOPQR
Enter and confirm the network name
(for using the input menu see descrip-
tion underneath fig. 18).
e) In the following two menus, set the
encryption method used by the router.
in front of the name indicates that
and confirm
[Manual confi g ]
or
Wired Wireless
DHCP enable
DHCP disable
6/9
BKSP
OK
CANCEL
depending
,
⑰