Setting Up The Module Via The Setup Wizard - Monacor PA-1200IRD Einbau- Und Bedienungsanleitung

5.2 Setting up the module via the
setup wizard
It is recommended to use the setup wizard for
setting up the module (date, time and network
settings). It is quick and easy.
Note: Any settings that can be made via the setup
wizard can also be made via the corresponding menu
items of the menu „System settings" (chapter 5.3).
1) On the welcome screen of the setup wizard
(fig. 4), is selected. To start the setup
YES
wizard, press the knob CONTROL SELECT to
confirm the setting
2) The time format menu will appear:
Date/Time
12/24 hour format
12
The 24-hour format is set for the time
(marked with an asterisk
12-hour format, turn the knob CONTROL
SELECT to select this format. Press the knob
to confirm the format selected.
3) The time update menu will appear:
Auto update
Update from DAB
Update from FM
Update from Network
No update
The current setting is marked with an aster-
isk (automatic time update via the Internet).
*
The other options are: automatic time update
via DAB station or FM station or manual time
setting (
No update
Note: The time will only be updated automatically
when a corresponding station is received. There-
fore, a setting should be selected that corresponds
to the operating mode most frequently used: For
example, if you mostly listen to DAB radio, select
.
Update from DAB
Confirm the current setting or select a differ-
ent setting and confirm. Depending on the
setting, the next menu will appear:
➧
Update from DAB
No further time settings are required. Con-
tinue with step 4: The menu in fig. 13 will
appear.
.
YES
⑧
24*
). If you prefer the
*
*
⑨
).
or
Update from FM
➧
Update from Network
The following menu will appear:
Set timezone
UTC +00:00: Dublin, Lon
UTC +00:30:
UTC +01:00: Madrid, A...
UTC +01:30:
UTC +02:00: Athen, Kai ...
Select the appropriate time zone for your
country and then confirm your selection.
The following menu will appear:
Dayli g ht savin g s
Dayli g ht savin g s
ON
For standard time, confirm
light saving time, select
Continue with step 4: The menu in fig. 13
will appear.
➧
No update
The menu for manual time setting will
appear:
Set Time/Date
01-01-2007
00:00
The digits for the day will flash. Turn the
knob CONTROL SELECT to set the day and
press the knob to confirm. The digits for
the month will flash. Proceed in the same
way to set the month, the year, the hours
and the minutes (and
format).
4) When the last time setting has been con-
firmed, the menu for permanent connection
to the network will appear:
Network settin g s
Keep network connected?
YES*
With , the connection to the network will
YES
always be maintained (required when the
module is to be controlled via the network,
e. g. via the app UNDOK™). With
*
⑩
⑪
OFF*
; for day-
OFF
and confirm.
ON
⑫
or for 12-hour
AM PM
⑬
NO
, the
NO
31