Operating Mode "Fm Radio; Display Indications In The Mode "Fm Radio - Monacor PA-1200IRD Einbau- Und Bedienungsanleitung

6.5 Operating mode "FM radio"

Press the button MODE repeatedly until
appears. The FM station last listened
radio
to will be replayed or, if the operating mode
is called up for the first time, the first possible
FM frequency received.
Station scan / station tuning
To start the scan, press the knob CONTROL
SELECT: The scan will start from the frequency
indicated and will stop at the first station. To
search for the next station, press the knob
again. To change the direction of the scan, first
turn the knob briefly in the desired direction
before starting the scan (to the left: change to
backward scan; to the right: change to forward
scan). If required, fine-tune a frequency that
has been found in steps of 50 kHz by turning
the knob.
Alternatively, the scan can be performed
◀◀
▎
via the buttons
▶▶ ◀◀
▎ ▎
(forward) or
the scan starts.
Saving a station
Calling up a station that has been saved
Ten stations can be saved for this operating
mode. The procedure for saving a station and
calling up a station that has been saved is the
☞
same as in the operating mode "Internet radio":
chapter 6.2 „Saving a station / podcast" and
„Calling up a station /podcast that has been
saved".
Changing the scan setting
The station scan is set at the factory in such a
way that it will only stop for stations with good
reception. To stop the scan also for stations with
poor reception, press the button MENU. The
menu for the operating mode "FM radio" will
appear:
FM
Scan settin g
Audio settin g
System settin g s
Main menu
is selected. Press the knob
Scan settin g
CONTROL SELECT. The following confirmation
prompt will appear:
▶▶
▎
TUNE : Keep the button
(backward) pressed until
>
>
>
㊺
FM station scan
FM
Stron g stations only?
YES*
Turn the knob CONTROL SELECT to select
and press the knob to confirm.
Mono mode
To reduce the noise from stations with poor re-
ception, select the mono mode: Press the button
MENU. The menu
Audio settin g
firmation prompt will appear:
FM weak reception
Listen in Mono only?
YES
Select the setting
will be reproduced in mono.
6.5.1 Display indications in the
mode "FM radio"
If the station broadcasts RDS information, the
display will show the station name instead of
the frequency (may take a few minutes). Some
stations also give information about the pro-
gramme and /or the current music title.
FM
Station name
Information
The icons in the line at the bottom mean:
RDS (Radio Data System) = transmission
R . D . S
of additional information
stereo replay
signal strength
Press the button INFO repeatedly to show addi-
tional information.
㊻
NO
will appear (fig. 45). Select
FM
and confirm. The following con-
㊼
NO*
and confirm. All stations
YES
12:45
㊽
R . D . S
NO
43