Monacor PA-1200IRD Einbau- Und Bedienungsanleitung Seite 33

7) If access to the network is encrypted, a menu
for entering the network key will appear
(if the WPS menu shown in fig. 19 appears in-
stead: continue as described in that section):
Key:
0123456789._- ,
abcdef g hijklmn
opqrstuvwxyzABC
DEFGHIJKLMNOPQR
To select the characters and the three com-
mand buttons, turn the knob CONTROL SE-
LECT and press the knob to confirm.
= delete last character
BKSP
= confirm the key
OK
= return to previous menu
CANCEL
Note: To select the command buttons
and , turn the knob backwards beyond
CANCEL
the first digit or forward beyond the last special
character.
The network connection will be established
when the key has been confirmed.
If the router supports WPS (Wi-Fi Protected
Setup), the WPS menu will appear instead of
the menu for the network key:
WPS Menu
Push Button
PIN
Skip WPS
WPS can be used to integrate a device into an
encrypted wireless network without having
to enter the network key. Two methods are
available.
Method 1: If the router supports WPS by
push button (PBC Push Button Configura-
tion), this method should be used:
is selected. Press the knob CONTROL
Button
SELECT to confirm. The following menu will
appear:
WPS Setup
Push WPS
button at the
other end
Press SELECT to
continue
First press the WPS button on the router,
then press the knob CONTROL SELECT on the
module. The connection will be established.
BKSP
OK
⑱
CANCEL
,
BKSP OK
>
>
>
⑲
Push
⑳
For the detailed procedure, also follow the
instructions in the manual / user interface of
the router!
Method 2: If the router supports WPS via
input of a PIN code, this method can also
be used as an alternative: Select and con-
firm : The menu
PIN
displaying an 8-digit PIN code. Enter this PIN
code on the router and press the knob CON-
TROL SELECT on the module. Then start the
connection setup on the router. For the de-
tailed procedure, also follow the instructions
in the manual / user interface of the router!
If use of WPS is not desired, select
and confirm: enter the network key as
WPS
described beneath fig. 18 and confirm.
8) The setup of the network connection will
be displayed:
Network settin g s
Please wait
Connectin g ./
When the network connection has been
established, the message
appear followed by:
Setup wizard
Setup wizard
completed
Press SELECT to exit
Press the knob CONTROL SELECT to termi-
nate the setup: the main menu will appear.
Use the main menu or the button MODE
to select the operating mode desired (chap-
ter 6.1.1).
If the connection fails to be established, check
the settings of your router (e. g. the SSID, the
WPS method used or the network key) before
trying again. To improve wireless reception, it
may help to reduce the distance between the
device and the router or to adjust the position
of the wireless LAN antenna.
In case of incorrect connection, reset the
network settings (menu "System settings"
➜ Network ➜ Clear network settin g s
try again.
will appear,
WPS Setup
Skip
㉑
will
Connected
㉒
) and
33