Ferm TSM1033 Originalbetriebsanleitung Seite 7

Material to be processed
This powertool is intended as a stationary
machine for making straight lengthways and
crossways cuts in hard and soft wood free from
foreign bodies such as nails, screws and mortar.
ATTENTION! When using electric tools to protect
against electric shock, injury and fire the following
basic safety measures must be observed.
Make sure to read all of these instructions before
you use this power tool, keep the safety booklet
and preserve it well for later reference.
1. Always keep your workplace clean and tidy.
• An untidy workplace can lead to unwanted
accidents.
2. Consider environmental influences.
• Do not expose the power tool to rain.
• Do not use the power tool in a damp or wet
environment.
• Make sure that your working space has
sufficient lighting.
• Do not use the power tool in areas where
there is a fire or explosive hazard.
3. To protect yourself from an electric shock.
• Avoid body contact with grounded parts
(e.g. pipes, radiators, electric stoves,
refrigerators etc.).
4. Keep other people away
• Keep other people away especially
children, do not let them touch your power
tool or cable and keep the children away
from your working area.
5. Store the unused power tools safely.
• Unused power tools should be locked up or
stored in a place that is dry and out of reach
of children.
6. Do not overload your power tool.
• You work better and safer in the specified
power range.
7. Use the correct power tool.
• Do not use low-power machines for heavy
work
• Do not use the power tool for purposes that
they are not intended for. For example you
cannot cut tree limbs or a log of wood using
a hand saw.
8. Wear suitable clothing.
• Do not wear loose clothing or jewelry; they
can be caught in the moving parts.
• When working outdoors non-skid footwear
is recommended.
• For long hair, wear a hairnet.
9. Use protective equipment.
• Wear protective goggles
• When doing work that generates dust, use
a breathing mask.
10. Connect the vacuum device
• If connection to the vacuum and catcher
are available then you know that these are
connected and properly used.
11. Do not use the cable for purposes that it is not
intended for.
• Do not use the cable to the connector to
pull it out of the socket. Protect the cable
from heat, oil and sharp edges.
12. Secure the power tool.
• Use clamps or a vice to hold the power
tool. It is safer than holding it with your
hand.
13. Avoid an abnormal posture.
• It ensures stability and keeps you balanced
at all times.
14. Keep and maintain tools with care.
• Keep the cutting tools sharp and clean, this
ensures that you work better and that it is
as safe as possible.
• Follow the lubricating and tool changing
instructions.
• Check the connection cable of the power
tool regularly and let a qualified expert
repair any damages.
• Check the extension cables regularly and
replace them if they are damaged.
• Keep the handles clean, dry and free of
grease and oil.
15. Unplug the power tool from the power outlet.
• When you are not using the power tool,
when you conduct maintenance and when
you change your tools such as blades, drills
and cutters.
16. Do not leave the key inside the tool.
• Before switching it on, make sure that keys
and setup tools have been cleared
17. Avoid unintentionally switching the power tool
on.
• Verify that while connecting the plug into
the socket that the power is off.
18. Use the extension cables while outdoors.
• When using the power tool outdoors make
sure to use the appropriate and approved
labeled extension cable.
7