Utility Menu - Denon DJ X1800 PRIME Benutzerhandbuch

For all sweep effects, the center ("12:00") position of the Sweep FX knob bypasses the effect.
Turning the Sweep FX knob clockwise or counter-clockwise from this position applies the
effect, and can produce different results in each direction depending on the type of effect. The
available sweep effects and their functions are as follows:
•
Dub Echo: This effect adds a brief echo. Turn a Sweep FX knob counter-clockwise to
decrease the length of the delay and increase the feedback, or turn it clockwise to
increase the length of the delay as well as the feedback.
•
Noise: This effect adds noise to the signal. Turn a Sweep FX knob counter-clockwise to
add white noise with a time-based gate effect synchronized with the channel's tempo, or
turn it clockwise to add white noise.
•
Wash Out: This creates a transition effect. Turn a Sweep FX knob to its most counter-
clockwise (minimum) position to apply a 1/2-beat echo that will also mute the channel's
normal audio signal, or turn it to its most clockwise (maximum) position to apply a 1-beat
echo.
•
Gate: This effect applies a time-based gate effect to the signal. Turn a Sweep FX knob
counter-clockwise to apply a gate effect synchronized with the channel's tempo, or turn it
clockwise to apply a gate effect that attenuates the signal. The farther clockwise the knob
is turned, the greater the attenuation.

Utility Menu

The Utility menu enables you to customize various settings on X1800 PRIME that affect the audio
signal routing, effects module, input and output levels, and more.
To enter or exit the Utility menu, press Utility. Exiting the Utility menu also saves any changes you made.
While in the Utility menu, you can do any of the following:
•
To select an option, turn the FX Select/Enter knob.
•
To confirm your choice or enter a submenu, press the FX Select/Enter knob.
•
To return to the previous screen, press Back.
Below are descriptions of the different submenus in the Utility menu:
EQ
These settings determine how the Channel EQ knobs work.
•
Type: Select ISO to set the Channel EQ knobs' ranges to -∞ to +6 dB/+10 dB (as labeled).
Select EQ to set the Channel EQ knobs' ranges to -24 dB to +6 dB (for other players that may
need this setting).
•
High Cross Over: This is the crossover frequency between the High and Mid EQ knobs when
the Type is set to ISO: 1000 Hz–8000 Hz (in varying increments).
•
Low Cross Over: This is the crossover frequency between the Mid and Low EQ knobs when
the Type is set to ISO: 100 Hz–800 Hz (in varying increments).
•
Reset EQ Default: Select OK to return these Channel EQ settings to their default values, or
select Cancel to return to the previous menu.
14