Denon DJ X1800 PRIME Benutzerhandbuch Seite 15

Filter
•
Resonance: This is the resonance of the filters on Channels 1–4 (i.e., how much the frequencies
just beyond the cutoff frequency are allowed to pass through the filter). 0 is a flat setting
(frequencies just beyond the cutoff frequency won't be heard at all), while 15 yields a high
resonance (the cutoff frequency is not as "strict," so some adjacent frequencies will be heard).
•
Extreme Type: This setting determines the effect of the Sweep Filters at the extreme low and
high ends. Select Kill for the filter extremes to end in silence, or select Bleed to allow the
extreme end of the filter to play.
Headphone
•
Attenuation: This is the gain level of the headphone output: -10 dB to +10 dB.
•
Split Cue Output: This sets which side of the stereo signal plays the Cue program on
headphones, Left or Right.
Microphone
These settings affect the microphones.
•
Attenuation: This is the gain level of the microphone inputs: -15 dB to +0 dB.
•
Gate Threshold: This setting changes the amount of audio required to engage the mic signal.
Different types of microphones may require this to be adjusted for best use: -40 dB to -79 dB.
•
Talk Over Level: This setting determines how much the master mix volume level is lowered
when the microphone talkover feature is activated: -40 dB to -20 dB.
•
Talk Over Resume: While using the talkover feature, the master mix volume will return to its
normal level after the microphone input detects no incoming signal. This setting determines
whether that transition occurs moderately (Normal) or quickly (Fast).
•
EQ High: This is the frequency band that will be affected by the High Mic EQ knob: 1000 Hz–
10,000 Hz (in varying increments).
•
EQ Low: This is the frequency band that will be affected by the Low Mic EQ knob: 100 Hz–900
Hz (in varying increments).
•
Headphone Receive: Select On to allow the microphone signal to be sent to the headphones.
Select Off to send the microphone signal to the master outputs only.
•
Reset Mic Default: Select OK to return the Mic settings to their default values, or select
Cancel to return to the previous menu.
FX
These settings affect the FX on X1800 PRIME.
•
FX Return: This is the unity level for the send outputs and receive inputs: -10 dB to +10 dB.
You may need to adjust this setting based on the types of external effects you are using.
•
Beat Break Edit: This menu enables you to select, edit, and store patterns for the BeatBreak
effect. See Effects > BPM Effect Module
To edit a pattern:
1. Turn the FX Select/Enter knob to select a pattern (1–16), and then press it.
2. Turn the FX Select/Enter knob to select one of 12 16th-notes in the pattern. You cannot edit
the four main beats of the pattern; they will always sound because they contain the audio
being sampled.
Press the FX Select/Enter knob to change the beat from a "hit"/"strike" ( █ ) to a rest ( __ )
or vice versa.
Repeat this step, if desired.
3. Press Back to return to the previous screen.
for more information about how this effect works.
15