Utility Menu - Denon DJ X1850 PRIME Benutzerhandbuch

Sweep FX
Sweep FX allows you to apply one of four effects to the four channels and "sweep" them using the Sweep
FX knobs. You can apply only one sweep effect at a time.
To activate a sweep effect, tap one of the Sweep FX buttons: Dub Echo, Noise, Wash Out, or Gate. The
button will light up when activated. Only one of these buttons can be enabled at a time.
To deactivate a sweep effect, tap the lit Sweep FX button. Alternatively, press a different Sweep FX button
to activate it, which will deactivate the other.
For all sweep effects, the center ("12:00") position of the Sweep FX knob bypasses the effect. Turning the
Sweep FX knob clockwise or counter-clockwise from this position applies the effect, and can produce
different results in each direction depending on the type of effect. The available sweep effects and their
functions are as follows:
•
Dub Echo: This effect adds a brief echo. Turn a Sweep FX knob counter-clockwise to decrease the
length of the delay and increase the feedback, or turn it clockwise to increase the length of the delay
as well as the feedback.
•
Noise: This effect adds noise to the signal. Turn a Sweep FX knob counter-clockwise to add white
noise with a time-based gate effect synchronized with the channel's tempo, or turn it clockwise to add
white noise.
•
Wash Out: This creates a transition effect. Turn a Sweep FX knob to its most counter-clockwise
(minimum) position to apply a 1/2-beat echo that will also mute the channel's normal audio signal, or
turn it to its most clockwise (maximum) position to apply a 1-beat echo.
•
Gate: This effect applies a time-based gate effect to the signal. Turn a Sweep FX knob counter-
clockwise to apply a gate effect synchronized with the channel's tempo, or turn it clockwise to apply a
gate effect that attenuates the signal. The farther clockwise the knob is turned, the greater the
attenuation.

Utility Menu

The Utility menu enables you to customize various settings on X1850 PRIME that affect the audio signal
routing, effects module, input and output levels, and more.
To enter or exit the Utility menu, press and hold Quantize/-Utility. Exiting the Utility menu also saves any
changes you made.
While in the Utility menu, you can do any of the following:
•
To select an option, turn the FX Select/Enter knob.
•
To confirm your choice or enter a submenu, press the FX Select/Enter knob.
•
To return to the previous screen, press Back.
Below are descriptions of the different submenus in the Utility menu:
EQ
These settings determine how the Channel EQ knobs work.
•
Type: Select ISO to set the Channel EQ knobs' ranges to -∞ to +6dB/+10dB (as labeled). Select EQ
to set the Channel EQ knobs' ranges to -24dB to +6dB (for other players that may need this setting).
•
High Cross Over: This is the crossover frequency between the High and Mid EQ knobs when the
Type is set to ISO: 1000Hz–8000Hz (in varying increments).
•
Low Cross Over: This is the crossover frequency between the Mid and Low EQ knobs when the Type
is set to ISO: 100Hz–800Hz (in varying increments).
•
Reset EQ Default: Select OK to return these Channel EQ settings to their default values, or select
Cancel to return to the previous menu.
13