Denon DJ X1800 PRIME Benutzerhandbuch Seite 17

•
Display:
Display Brightness: This setting changes the brightness of the OLED display: Low, Med,
o
or High.
LED Brightness: This setting changes the brightness of all LEDs on the control surface:
o
Low, Med, or High.
•
Engine Connect: Select Auto to enable X1800 PRIME to automatically receive timing and BPM
information (to synchronize effect tempos) from compatible media players connected to its Link
ports and to send track and user profile data between them. X1800 PRIME will also
automatically detect and configure each media player once you connect their Link ports. Select
Manual to disable automatic linking and only activate this feature manually by pressing and
holding the Engine Connect button until the Channel Assignment screen appears on the media
players. You can then freely assign each media player layer to a specific channel.
•
Cue Settings:
Cue Solo Mode: Select On to use the Channel Cue buttons as "solo" buttons (pressing
o
one will mute all other channels). Select Off to use them as normal cue buttons (pressing
one will send its signal to the cue channel).
Inactive Cue State: This setting determines the off state of the Cue LEDs: DIM or Off.
o
Cue 1–4 Color: This setting determines the color of the Cue buttons for each channel:
o
red, spring green, green, light blue, blue, yellow, orange, or purple.
Reset Cue Defaults: Select OK to return the Cue settings to their default values, or select
o
Cancel to return to the previous menu.
•
Contour Lock: When set to On, this setting locks the Crossfader Contour to the current knob
position so it is not changed if the knob is moved. Set to Off to disable the lock.
•
Through Position Lock: When set to On, this setting locks the Crossfader Assign switches to
the Thru position so it is not changed if the switch is moved. Set to Off to disable the lock.
•
Network Settings:
Refresh IP Address: Select OK to renew your IP address, which reestablishes the
o
connection between your X1800 PRIME and any compatible Denon DJ media players
connected to the Link ports. Select Cancel to return to the previous screen.
•
MIDI: These are MIDI settings that determine how the MIDI connections are used.
Clock Send: These settings determine whether or not X1800 PRIME will send MIDI Clock
o
messages over each of these connections. For each option, select On to enable
transmission or Off to disable it.

USB: This applies to both USB Ports 1 and 2. If you are using X1800 PRIME to
control software, set this to On.

5pin: This applies to the MIDI Out.
Active Send: These settings determine whether or not X1800 PRIME will send normal
o
MIDI messages over each of these connections. For each option, select On to enable
transmission or Off to disable it.

USB: This applies to both USB Ports 1 and 2. If you are using X1800 PRIME to
control software, set this to On.

5pin: This applies to the MIDI Out.
•
Factory Reset: Select OK to restore X1800 PRIME to its factory default settings (wait a few
seconds after selecting this before resuming normal operation). Select Cancel to return to the
previous screen.
17