Rear Panel - Denon DJ X1800 PRIME Benutzerhandbuch

Rear Panel

1. Power Input: Use the included power cable to connect this input to a power outlet.
2. Power Button: Press this button to power X1800 PRIME on or off. Power on X1800
PRIME only after you have connected all of your input devices and before you power on
your amplifiers and loudspeakers. Power off your amplifiers and loudspeakers before
powering off X1800 PRIME.
3. Link Ports: Use standard networking cables to connect these ports to your a compatible
Denon DJ media player and/or to your computer. Each networked media player can use
these connections share timing and BPM information with X1800 PRIME (to synchronize
effect tempos) as well as track and user profile data with other media players.
4. Master Outputs (balanced XLR): Use standard XLR cables to connect these outputs to
loudspeakers or an amplifier system. Use the Master knob on the top panel to control the
volume level.
5. Master Outputs (unbalanced RCA): Use standard RCA cables to connect these outputs to
loudspeakers or an amplifier system. Use the Master knob on the top panel to control the
volume level.
6. Record Outputs (RCA): Use standard RCA cables to connect these outputs to a recording
interface, external mixer, or other device. Use the Utility menu to select whether or not the
mix sent to these outputs will include the microphones' audio signal (see
Utility Menu >
7. Booth Outputs (1/4"/6.35 mm, TRS): Use standard 1/4"/6.35 mm cables to connect these
outputs to booth monitors or a booth amplifier system. Use the Booth knob on the top
panel to control the volume level. Use the Utility menu to select whether or not the mix
sent to these outputs will include the microphones' audio signal (see
Menu > Microphone).
8. Send Outputs (1/4"/6.35 mm, TRS): Connect these outputs to the inputs of an external
effects module or other device. You can use the Utility menu to set the level of this audio
signal (see Operation > Utility Menu > Advanced
9. Receive Inputs (1/4"/6.35 mm, TRS): Connect these inputs to the outputs of an external
effects module or other device. You can use the Utility menu to set the level of this audio
signal (see Operation > Utility Menu > Advanced
10. Phono/Line Inputs (RCA): Use standard RCA cables to connect these line-level or phono-
level inputs to an external audio source. Use the input selectors on the top panel to set
whether the signal from the line-level inputs or phono-level inputs will be sent to each channel.
10
Microphone).
Audio).
Audio).
Operation >
Operation > Utility