Denon DJ X1800 PRIME Benutzerhandbuch Seite 9

41. FX Cue: Press this button to preview the BPM effects in the headphones' cue channel.
Not all BPM effects can be previewed, though.
42. FX Time/Parameter: Turn this knob to select the rate that the BPM effect module will use.
Press the knob to switch between adjusting the rate as a time division and the rate in
milliseconds. (A corresponding light along the FX touch strip will illuminate to indicate the
current time division.) This knob will also adjust other FX parameters when available.
43. FX Touch Strip: When the Instant button is off (disabled), tap an area of this touch-
capacitive strip to select the time division that the BPM effect module will use. A
corresponding light along the strip will illuminate to indicate the current time division. If the
current time division is not a quantization value shown on the strip (e.g., the BeatBreak
effect), then none of the lights will illuminate.
When the Instant button is on (enabled), tap and hold your finger on the strip to activate
the effects, and then drag your finger up or down to adjust the time division of the effect.
44. Tap/-Auto: Tap this button at least 3 times at the desired tempo to set the rate of the
BPM effect module for the channel set by the FX Channel Assign knob (the module's rate
for other channels will remain unchanged). The Tap button will be dimly lit when using a
BPM manually entered this way.
Press and hold this button for 1 second to synchronize the rate of the BPM effect module
with the audio signal of the channel set by the FX Channel Assign knob (the module's rate
for other channels will remain unchanged). The Tap button will be brightly lit when using a
BPM automatically detected this way, and Auto will be shown next to the BPM in the
second display. If you are using a compatible Denon DJ media player with Engine Connect,
the media player will control the BPM effect module, and the Engine logo will be shown in
the second display.
45. FX Frequency: Turn this knob to select a frequency band of the audio signal to which the
BPM effects will be applied. Select the center (12:00) position to apply effects to the entire
spectrum of frequencies.
46. Utility: Press this button to enter or exit the Utility menu, which will appear in the display.
Exiting the Utility menu also saves any changes you made.
47. MIDI Clock: Press this button to send a MIDI Start or MIDI Stop message out of the USB
port or MIDI output (you can use the Utility menu to select one). The tempo will be that of
the selection of the FX Channel Assign knob. If you change the selection of the FX
Channel Assign knob, press and hold this button to send the new tempo.
48. Engine Connect: When the Link ports are connected to compatible Denon DJ media
players, press this button to enable X1800 PRIME to receive timing and BPM information
(to synchronize effect tempos) and to send track and user profile data between media
players.
49. USB Ports: Use standard USB cables to connect computers to these USB ports.
9