Denon DJ X1800 PRIME Benutzerhandbuch Seite 13

•
When the Instant button is off, tap an area of the FX touch strip to select a time
division. A corresponding light along the strip will illuminate to indicate the current
time division.
To adjust the rate of the BPM effect module in milliseconds, make sure the
millisecond rate (__ ms) is selected in the lower display (if it is not, press the FX
Time/Parameter knob), and then turn the FX Time/Parameter knob to adjust it.
To enter a new tempo, press Tap at least 3 times at the desired tempo. This will set the rate of the
BPM effect module for the channel set by the FX Channel Assign knob (the module's rate for other
channels will remain unchanged). The Tap button will be dimly lit when using a BPM manually
entered this way.
To detect the tempo automatically, press and hold Tap/-Auto for 1 second. This will synchronize
the rate of the BPM effect module with the audio signal of the channel set by the FX Channel
Assign knob (the module's rate for other channels will remain unchanged). The Tap button will be
brightly lit when using a BPM automatically detected this way, and Auto will be shown next to the
BPM in the second display.
Note: If you are using a compatible media player with Engine Connect, the media player will
control the BPM effect module, and the Engine logo will be shown in the second display.
To adjust the tempo manually, press and hold Tap/-Auto, and then turn the FX
Time/Parameter knob to adjust the BPM in increments of 1. While still holding Tap/-Auto,
press and turn the FX Time/Parameter knob to adjust the BPM in increments of 0.1.
You can easily adjust the balance between the "wet" signal (the BPM effect module's output
signal) and "dry" signal (audio without effects applied).
To adjust the balance between the "wet" and "dry" signals, turn the Wet/Dry knob.
Alternatively, use the FX touch strip while in Instant FX Mode.
Normally, you would apply effects to the entire frequency spectrum, but X1800 PRIME also
lets you apply them to an isolated frequency band of the audio signal (of the selected channel).
To select the frequency band, turn the FX Frequency knob. Select the center (12:00)
position to apply effects to the entire spectrum of frequencies.
Instant FX Mode enables you to use the FX touch strip to activate the effect and adjust its time
division simultaneously.
To enable or disable Instant FX Mode, press Instant. The button will light up when it is
enabled.
To activate the effect, tap and hold your finger on the FX touch strip, and then drag
your finger up or down to adjust the time division of the effect.
Sweep FX
Sweep FX allows you to apply one of four effects to the four channels and "sweep" them using
the Sweep FX knobs. You can apply only one sweep effect at a time.
To activate a sweep effect, tap one of the Sweep FX buttons: Dub Echo, Noise, Wash Out,
or Gate. The button will light up when activated. Only one of these buttons can be enabled at
a time.
To deactivate a sweep effect, tap the lit Sweep FX button. Alternatively, press a different
Sweep FX button to activate it, which will deactivate the other.
13