Troubleshooting; Possible Cause - Scheppach PHT600 Original Bedienungsanleitung

13. Troubleshooting

Fault
Hedge trimmer does not run
Hedge trimmer cuts with
interruptions
Motor runs, cutting device
remains stationary
Cutting device gets hot
30 | GB

Possible cause

• No fuel
• Fault in the fuel line
• Fuel filter clogged
• Spark plug is defective
• Carburettor defective
• Internal fault
• Internal fault
• On/off switch defective
• Cutting device blocked
• Internal fault
• Clutch defective
• No lubrication → friction
• Not enough sliding clearance
• Cutting device is blunt
www.scheppach.com
Remedy
• Check the fuel quantity
• Check the fuel line for kinks or damage
• Clean or replace the fuel filter.
• Replace spark plug
• Contact the manufacturer or the
responsible customer service point
• Contact the manufacturer or the
responsible customer service point
• Contact the manufacturer or the
responsible customer service point
• Contact the manufacturer or the
responsible customer service point
• Remove object
• Contact the manufacturer or the
responsible customer service point
• Contact the manufacturer or the
responsible customer service point
• Oiling the cutting device
• Adjust the sliding clearance
• Have the cutting device sharpened