Troubleshooting - Scheppach TPH500 Original Bedienungsanleitung

13. Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip­
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest
service workshop.
Fault Possible cause
Machine does not Supply voltage not on
start
On/Off switch faulty
Worn carbon brushes
Motor faulty
Power cable damaged
Machine works with Power cable damaged
interruptions
Internal connections are loose
On/Off switch faulty
Poor cutting quality Blades are blunt.
Motor is running but The power unit is jammed by a thick
the gears are not branch or other objects.
engaging
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Check the socket or the electricity supply;
if required, arrange repair by an authorised
electrician.
Contact the service centre
Contact the service centre
Contact the service centre
Check the extension lead and have it replaced,
if required.
Check the extension lead and have it replaced,
if required.
Contact the service centre
Contact the service centre
Have the blades sharpened or the knife bar
replaced.
Turn the hedge trimmer off immediately, dis­
connect the electricity supply and remove the
blockage.