HOMCOM 800-139 Bedienungsanleitung Seite 8

m ê É ë ë á å Ö = í Ü É = D l k L l c c D = Ä ì í í ç å = ï á ä ä = í ì ê å = í Ü É = ì å á í = ç Ñ Ñ K =
TIMER SETTING- UNIT OFF SETTING: The unit will automatically turn off once
the set timer is up.
TIMER SETTING- UNIT ON SETTING: The unit will automatically turn on once the
set timer is up.
Press the 'TIMER' button so the display shows '1H'. Press '+' or '-' to set the time.
During this process, the 'H' will flash. Five seconds after time is selected, the 'H'
will remain lit, indicating the setting is complete.
5. Draining water: Remove the water draining cap at the bottom of the unit and
drain the water. It is best to change the water every 24 hours and clean the unit
every three days.
Automatic self-cleaning programme
Starting the self-cleaning programme: Plug in the unit, and hold the
'TIMER/CLEAN' button on the control panel for longer than five seconds. The
symbol < > will start rotating. It takes approximately 20 minutes to complete
one cycle and will turn off automatically once finished.
Cancel the self-cleaning program: It takes about 20 minutes to complete one
self-cleaning program. When the program is over, the system will be in off-state
automatically. And also you can press the "ON/OFF" button on control panel to
cancel the self-cleaning program by force.
Warning
A. Check the water tank, filter and separator pipe is not blocked. Regularly
clean them.
B. The water temperature will affect the capacity of ice cubes made. The lower
the temperature, the larger quantity of ice cubes produced .
C. The ambient temperature will affect the capacity of ice cubes made. The
lower the temperature, the larger quantity of ice cubes produced.
D. Always use good quality water to make sure the pump work well. Bad quality
water will cause pump noise, but doesn't effect the unit working.
E. The compressor restart 3mins later if you turn off the unit.
TROUBLESHOOTING
PROBLEM
< > is on.
< > is on.
The water reservoir has
water, but< > is on.
<E1> is on
<E2> is on
No water in the water
Separator pipe
EN
POSSIBLE CAUSE
Lack of Water.
Too many ice cubes in the
basket.
Fault with the solenoid valve.
Fault with the ambient
temperature sensor.
Fault with the ambient
temperature sensor.
The holes are blocked.
Water filter is blocked.
7
SOLUTION
Turn off the unit and add water to
the <FULL> level, and restart the
unit.
Remove the ice cubes in the basket.
Check with a qualified technician
The unit can still work. Change the
sensor.
The unit can still work. Change the
sensor.
Clean out each hole until the
water can flow.
Clean the water filter.