Adjustments; Adjusting The Head Strap, Fig. A; Adjusting The Ear Protectors, Fig. B - D; Adjusting The Visor, Fig. E - Parkside PFSH 3 A2 Originalbetriebsanleitung

■ The pads of the ear protectors will show signs
of wear over time. Examine them for tears or
loose spots after each use.
■ Do not clean the ear protectors with chemicals
or substances that are harmful to the wearer.
■ Certain chemical substances can damage this
product. Detailed information is available from
the manufacturer.
■ Ear muffs and especially their foam padding
can wear down over time. Examine them
regularly for tears, loose spots and other signs
of wear.
■ Covering the foam pads with hygiene covers
can compromise the acoustics of the ear muffs.
WARNING!
► Failure to comply with the safety instructions
provided for the helmet-ear muffs combina-
tion can seriously compromise their protective
effect.
■ Always flip down the visor when wearing the
helmet.
■ It protects you from flying objects.
■ The visor does not offer protection from splash-
ing liquids (including liquid metals), hot objects,
electricity and infrared/UV rays.
■ If the visor and the helmet/ear muff combi-
nation bear different marks for mechanical
strength, the lower degree of mechanical
strength must be assigned to the full eye and
face protection.
■ Do not use the visor in environments with a pre-
dictable risk from hard or sharp flying objects.
■ Wood shavings and their resin can damage the
visor and impair its transparency.
WARNING!
► The visor is tested for increased mechanical
strength and corresponds to mechanical
strength class "S".
│ GB │ IE │ NI
■ 4

Adjustments

Adjusting the head strap, fig. A
♦ Turn the head strap adjuster
head strap to fit your head.
♦ The headband should fit your head snugly
when you put on the helmet.
♦ Tighten the headband by turning the head strap
adjuster clockwise.
♦ Loosen the headband by turning the head strap
adjuster anticlockwise.
■ The helmet must sit firmly on your head without
exerting uncomfortable pressure.
CAUTION!
►
Always make sure that the helmet is adjusted
correctly when using it.
Adjusting the ear protectors, fig. B - D:
You can adjust the height and position of the ear
protectors .
♦ Push down the bracket of the ear protectors
to lock the ear protectors
♦ Slide the ear protectors
them to the required height (see fig. B).
♦ Turn the ear protectors
required position (see fig. C).
♦ Flipping the ear protectors
it easier to put them on or take them off.
If the tension decreases, take the helmet off first.
Adjust the tension while folded in by using the
ear protector adjuster
♦ Slide the ear protector adjuster
"+" to increase the tension (see fig. D).
♦ Slide the ear protector adjuster
"–" to decrease the tension (see fig. D).
Adjusting the visor, fig. E
You can adjust the distance between the visor
and your face by moving the visor manually (see
fig. E).
Alternatively, you can flip the visor
to adjust the
onto your ears.
up or down to set
to set them to the
outwards makes
(see fig. D).
towards the
towards the
all the way up.
PFSH 3 A2