General Safety Instructions - Parkside PFSH 3 A2 Originalbetriebsanleitung

H-value M-value
(high (medium
level) level)
29 dB 21 dB
Explanation of the symbols used on the helmet:
Figure F:
1 CE marking
2 Applied standard
3 Helmet size
Figure G:
4 Material
Figure H:
5 Month of manufacture
6 Year of manufacture (e.g. 2021)
Explanation of symbols on the visor:
Figure I:
7 Manufacturer type
8 Applied standard
9 Symbol for increased strength
Applied standards:
The helmet has been examined as per:
EN 397: 2012+A1: 2012
The ear protectors have been audited as per:
EN 352-3: 2002
The visor has been audited as per:
EN 1731: 2006
Identification number, name and address of
the inspection body:
2754 ALIENOR CERTIFICATION
ZA du Sanital – 21 Rue Albert Einstein
86100 CHATELLERAULT-France
PFSH 3 A2
L-value SNR
(low level) value
(single
number
rating)
12 dB 23 dB
General safety
instructions
WARNING!
► Read all safety warnings and all instructions.
Save all warnings and instructions for future
reference.
Please pay close attention to the following informa-
tion and safety instructions to ensure the best possible
protection and comfort.
■ Whenever you use the helmet, first check that
all components are properly attached, adjusted
and serviced.
■ Always use the helmet with the correct settings
to ensure the required protection.
■ The helmet cannot guarantee complete protec-
tion against injury. It does not replace adher-
ence to safe work procedures.
■ Never modify the structure or varnish of the
helmet.
■ The helmet must not come into contact with
liquids containing solvents or alcohol. These
substances can damage the plastic.
■ Knocks or other impacts can cause impercep-
tible impact damage to the helmet, such as
hairline cracks. This compromises the protection
afforded by the helmet, especially in emergen-
cies. Replace the helmet if it has been subject to
extreme stresses.
■ Examine the helmet for damage (cracks, tears)
before every use. Only use the helmet and ac-
cessories if they are in a flawless condition.
■ Do not modify the helmet as this could compro-
mise its protective effect.
■ Please adhere to all instructions and tips
re garding assembly, adjustments and mainte-
nance of the ear protectors.
■ The ear protectors are intended to protect your
ears in noisy areas.
■ They should be worn for as long as the noise
persists.
GB │ IE │ NI │
3 ■