Use; Automatic Operation; Manual Operation - Piazzetta MULTIFUOCO 2003 Einbau- Und Bedienungsanleitung

7.0 USE

After having provided power to the fan kit, wait a few seconds before pressing the remote control
buttons to allow the check-up of the electronic boards.
Two types of operations can be selected with the remote control.

AUTOMATIC OPERATION

To start the fan in the automatic mode, proceed as follows:
- Light the fi re,
- press the AUTO button (the number of beeps emitted indicates the speed at which the fan is set),
- set the speed desired pressing the +/- remote control buttons lightly choosing from among four different operating
speeds (V1 – V2 – V3 – V4),
- the fan starts only when the probe detects the turn-on temperature,
- the fan will shut-off when the temperature detected by the probe falls below the minimum threshold,
- the fan in operation can be turned off at any time clicking the ON/OFF button (the long beep signals the shutting-
down of the system) and it will not start-up even if the probe reaches the start-up temperature.
To restart the fan, it's necessary to press the "ON/OFF" or also the "AUTO" button.
If the fan shuts off automatically, it will start again in the same mode if the probe detects a
temperature reading greater than the turn-on threshold.

MANUAL OPERATION

To start the fan in the manual operation mode, proceed as follows:
- press the ON/OFF button (the number of beeps emitted indicates the speed at which the fan is set),
- set the speed desired pressing the +/- remote control buttons lightly choosing from among four different operating
speeds (V1 – V2 – V3 – V4),
- the fan starts immediately when the temperature detected by the probe exceeds the turn-on value, the type of
operation commutes to the predefi ned automatic mode and will shut down when the probe reaches the shutdown
temperature,
- the fan in operation may be shut-off at any time clicking the ON/OFF button (the long beep indicates the shutting
down of the system).
If the system comes started in manual modality with cold stove and the probe does not fi nd the
necessary temperature in order to activate the automatic functioning, the fan will continue to
work till that the ON/OFF botton will be pressed.
20 H07003370 / DT2000088 - 02
DT2011493-00