Specifications; Stihl Ap Battery; Noise And Vibration Data - Stihl SPA 65 Gebrauchsanleitung

19 Specifications

Condition LEDs on Bat‐
tery
Special harvester 3 LEDs glow
cuts out during red.
operation.
Special harvester
runtime is too
short
19 Specifications
19.1 STIHL SPA 65 Special Har‐
vester
Approved batteries:
• STIHL AP
• STIHL AR
– Weight without battery: 3.3 kg
– Length: 2.26 m
For battery life see www.stihl.com/battery-life.
19.2

STIHL AP battery

– Battery Technology: Lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Permissible temperature range for operation
and storage: -10°C to +50°C
19.3

Noise and Vibration Data

K-value (uncertainty) for sound pressure levels is
2 dB(A). K-value (uncertainty) for sound power
levels is 2 dB(A). K-value (uncertainty) for vibra‐
tion levels is 2 m/s².
STIHL recommends that you wear hearing pro‐
tection.
– Sound pressure level L
to ISO 22868: 84 dB(A)
– Sound power level L
ISO 22868: 95 dB(A)
– Vibration level a measured according to
hv
EN 60745-2-13;
0458-704-9921-D
Cause
No electrical contact
between special har‐
vester and battery.
Special harvester or
battery damp.
Special harvester is
too hot.
There is a electrical
malfunction.
Battery not fully char‐
ged.
Normal battery life
has been exceeded.
measured according
pA
measured according to
wA
Remedy
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
► Remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Allow the special harvester or battery to
dry.
► Remove the battery.
► Allow the special harvester to cool down.
► Remove battery and insert it again.
► Switch on the special harvester.
► Recharge the battery fully as described in
the instruction manual for the STIHL AL
101, 300, 500 chargers.
► Replace the battery.
• Control handle: 2.5 m/s² K-value for vibra‐
tion level is 2 m/s².
• Loop handle: 2.5 m/s²
The vibration values quoted above have been
measured according to a standardized test pro‐
cedure and may be used to compare electric
power tools. Depending on the type of usage,
the vibrations that actually occur may differ from
the values quoted. The vibration values quoted
may be used for an initial assessment of the
user's exposure to vibrations. The actual expo‐
sure to vibrations has to be estimated. This proc‐
ess may also take into account times during
which the electric power tool is switched off and
times during which it is switched on but running
off load.
Information on compliance with Vibration Direc‐
tive 2002/44/EC is available at www.stihl.com/
vib.
19.4 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
English
29