Adjusting Special Harvester For User; Removing And Fitting The Battery; Inserting The Battery - Stihl SPA 65 Gebrauchsanleitung

8 Adjusting Special Harvester for User

1
2
► Screw the tine (1) into the rake (2) and tighten
it down firmly by hand.
► Use a 16 mm ring wrench to turn the tine (1)
another 1/8 turn.
7.1.2 Removing the Tines
► Switch off the special harvester, push retaining
latch to position and remove the battery.
► Loosen tine with a 16 mm ring wrench.
► Unscrew the tine by hand.
7.2 Mounting the Machine Support
► Switch off the special harvester, push retaining
latch to position and remove the battery.
1
2
► Position the left half of the machine support (2)
against the side of the cover.
► Fit the screw (1).
► Position the right half of the machine support
(4) against the side of the cover.
► Fit the screw (5).
► Insert and tighten down the screws (4) firmly.
► Tighten down the screws (1) and (5) firmly.
The machine support (2) need not be removed
again.
0458-704-9921-D
1
5
3 4
8 Adjusting Special Har‐
vester for User
8.1 Fitting and Adjusting the Carry‐
ing System
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the cara‐
biner (2) is about a hand's width below your
right hip.
9 Removing and Fitting the
Battery
9.1

Inserting the battery

1
2
► Insert the battery (1) up to the limit stop into
the battery compartment (2).
The battery (1) engages with a click and is
now locked.
9.2 Removing the Battery
► Place the special harvester on a level surface.
► Hold one hand in front of the battery compart‐
ment to ensure the battery (2) does not fall
out.
1
English
1
2
1
2
25