Vacuuming Of Liquids - Nilfisk T75 Betriebsanleitung

Vacuuming of liquids

CAUTION!
Comply with the safety regulations governing the
vacuumed materials.
CAUTION!
Make sure the liquid stop device is working
correctly before vacuuming liquids.
If foam forms, turn off the machine immediately
and empty the container.
Warning: switch off the machine immediately if
foam or liquid leaks out.
Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
Dirty liquid vacuumed up by the machine must be
considered conductive.
CAUTION!
Do not use the machine if the liquid mechanical stop is
not installed!
If it's used without the float, the machine may be
seriously damaged.
CAUTION!
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.
The machine vacuums liquids and deposits them into the
container.
en t e mac ine vacuums li uids it must e e uipped wit
liquid mechanical stop.
The liquid mechanical stop requires a special container with
relevant nozzle.
e ore startin t e mac ine, close t e inlet on t e filterin
c am er wit t e relevant plu and fit t e vacuum ose in t e
inlet on t e dust container, t en fit t e re uired tool on to t e
end part of the hose (refer to the manufacturer's accessory
catalogue or Service Centre).
The liquid mechanical stop stops the vacuuming operation (the
vacuuming units remain activated) when the liquid container is
ull it is t en necessary to turn o t e mac ine and empty t e
liquid container.
T e mac ine does not switc o automatically.
7
T75
GB
C360