Installation Location - UNIMAT 1001010 Bedienungsanleitung

• Unplug the unit from power and let the device cool
down before cleaning.
• Do not the use the device with an external timer or a
separate remote control system.
ATTENTION: This device uses steam pressure!
Never remove the water tank or filter holder during
operation. There is a risk of burns or scalding. This can also
damage the device. The entire operating display must light up
at the end of the brewing phase. Only then can the filter
holder be removed. To remove the water or milk tank, the
device must be switched off using the ON/OFF switch, the
operating display goes out.

Installation location

Place the device out of reach of children.
•
Place the device indoors on a dry, level and firm surface.
•
Keep the electrical part of the device away from moisture, open
•
flame and extreme heat.
Do not lay the connection cable over sharp edges. The connection
•
cable cannot be pulled tight, bent, come into contact with hot
surfaces or present a tripping hazard.
Do not cover the device during operation.
•
The power outlet must be accessible so that the connection to the
•
power grid can be separated quickly in the event of a malfunction.
23