Safety Instructions For Installation And Maintenance Work; Unauthorised Conversion And Production Of Spare Parts - Armstrong HEP Optimo S Basic Original Einbau- Und Betriebsanleitung

• Observe the instructions in
local or general regulations
(e.g. IEC, VDE, etc.),
and those of the
local energy supplier.
• In the event of hazards
arising from the system due
to contact with hot or cold
parts, these parts must be
fitted with a touch guard.
• Keep flammable substances
away from the product.
2.7 safety instructions
for installation and
maintenance work
The system operator is
responsible for ensuring that
all installation and mainten-
ance work is carried out by
qualified personnel. These
persons must also have
familiarised themselves in
advance with the product
using the operating
instructions. Conducting work
on the pump is only permitted
when the system is shut down.
Ensure that the device is
HEP Optimo S Basic
securely disconnected from the
power supply. Disconnect the
device plug to achieve this.
Prescribed instructions for
shutting down the device can
be found in the operating
instructions. All protective
mechanisms, such as a touch
guard, must be correctly
reattached after work.
2.8 unauthorised conversion
and production of spare
parts
Modification or conversion of
the product is only permitted
after prior consultation with the
manufacturer. Only use original
spare parts for repairs. Only use
accessories that have been
approved by the manufacturer.
The manufacturer shall bear no
liability for any consequences
resulting from the use of other
parts.
operating instruction
23