Service & Maintenance - Ferm MSM1021 Originalbetriebsanleitung

• Turn on the machine using the switch
• Bring the saw slowly downwards so the saw
blade saws through the piece of work
• Push the machine slowly backwards (in
direction of guide fence)
• Bring the machine gently up again and switch
it off by letting go of the switch
Problem solving
1. The motor does not start
• The plug is not in the socket
• The power cord is broken
• The switch is defective. Take the machine to
your dealer for repair.
2. The saw cut is not even (jagged)
• The saw blade must be sharpened
• The saw blade is mounted back to front
• The saw blade is clogged with resin or
sawdust
• The saw blade is not suitable for the piece of
work being used
3. The height and/or mitre lever is obstructed
• Chips and/or dust must be removed
4. The motor has difficulty in reaching full
speed
• The extension cord is too thin and/or too long
• The mains voltage is less than 230 V
5. The machine vibrates excessively
• The saw blade is damaged
6. The machine becomes excessively hot
• The ventilation slots are blocked. Clean them
out with a dry cloth.
7. The electromotor runs unevenly
• The carbon brushes are worn out. Replace the
carbon brushes or consult your dealer.
5. SERVICE & MAINTENANCE
Maintenance
Always make sure that the machine is
not connected to the mains electricity
when you carry out any maintenance of
the mechanism.
Slide rails
Dirt can damage the slide rails and thereupon the
operating of the machine.
• Clean the slide rails regularly with a soft cloth.
• Drip some lubricating oil on the slide rails
• Move the mitre saw forwards and backwards
so the oil spreads over the complete rails
These machines are designed to function for a long
time without any problems with a minimum of
maintenance. By cleaning the machine regularly
and using it in the correct way you can contribute to
a long life of your machine.
Cleaning
Clean the machine housing regularly with a soft
cloth, preferably after each time you use the
machine. Make sure that the ventilation slots are
free of dust and dirt. For stubborn dirt use a soft
cloth dampened with soapy water. Never use
solvents such as benzene, alcohol, ammonia, etc.
These types of solvents can damage the plastic
parts.
Lubrication
The machine does not need extra lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please
contact the service address on the warranty card. In
the back of this manual you find an exploded view
showing the parts that can be ordered.
Environment
To prevent damage during transport the machine
is delivered in sturdy packaging. The packaging is
made of recyclable material wherever possible,
so make use of the possibility of recycling the
packaging. When you replace a machine, take
the old one to your local dealer. Here it will be
dealt with in an environmentally friendly way.
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.
Warranty
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
9