Ferm MSM1021 Originalbetriebsanleitung Seite 5

9. Knob adjusting saw angle
10. Locking knob
11. Fixing knob clamp
12. Handle adjusting bevel angle
13. Connection dust bag
14. Slide rail
15. Bevel angle
16. Handle
17. Cover
18. Saw blade bolt
19. Flange
20. Screw
21. Extension pieces (left and right)
22. Lock-button saw blade
23. Bolts
Contents of the package
1 Radial mitre saw
1 Dust bag
1 Clamp
1 Key for changing the saw blade
1 Instructions for use
1 Safety instructions
1 Warranty card
Check the machine, loose parts and accessories
for transport damage.
2. SAFETY
When using the machine, always
carefully follow the safety precautions
supplied and the safety instructions
given below.
List of symbols
The following pictograms are used in these
instructions and on the machine itself:
CE Conforms to the applicable
European safety standards.
Class II equipment – double insulated
– the plug does not have to be earthed
Read the operating instructions carefully.
Denotes risk of personal injury, loss of
life or damage to the tool in case of
non-observance of the instructions in
this manual.
Indicates the presence of an electrical
voltage.
Immediately unplug the plug from the
mains electricity in the case that the cord
gets damaged and during maintenance.
Keep bystanders away.
Wear eye and ear protection.
Before each use of the saw
Check the machine. If any part of the machine is
missing, bent or in any other way unusable, or
when an electrical defect occurs, turn the
machine off and take the plug out of the socket.
Replace all missing, damaged or defective parts
before using the machine again.
To fix the saw blade in the slot and to prevent the
piece of work from moving, follow the instructions
below.
• Choose a suitable saw blade for the work. Use
the crosscut saw only for sawing wood and
wood derivatives or light metal such as
aluminium. Other materials can jump away or
get caught in the saw blade or give rise to
other dangers.
• The arrow marked on the saw blade, which
indicates the direction of rotation, must point in
the same direction as the arrow marked on the
machine. The saw blade teeth must point
downwards on the front of the saw.
• Check that the saw blade is sharp,
undamaged and correctly aligned. After
unplugging the machine, push the saw hood
downwards. Rotate the saw blade by hand
and check that it revolves freely. Put the
machine in the 45° position and check free
rotation again. If the blade touches anything it
must be adjusted.
5