Herunterladen Inhalt Inhalt Diese Seite drucken

SOLARWATT Vision 36M glass Montageanleitung Seite 19

Ungerahmte glas-glas module
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Also not allowed are modifications of the solar module, such as the conversion to the use
of the heat generated in the form of a thermal solar collector. If there is no approval in
the form of a manufacturer's declaration or exceptional approval, the solar modules may
not be installed in locations where there are aggressive ambient conditions. Furthermore,
the use of the products on mobile units such as vehicles or ships is not permitted.
Make sure that there are no components such as cable ties, fasteners or similar materials
between the mounting rails and the backside of the module. When the modules are in-
stalled vertically (portrait), the bottom row modules must be positioned with the junction
box towards the ridge.
During installation, avoid creating shades with the module clips or installation system to
improve the energy yield.
Comply with the minimum distance of 5 mm between the solar modules to allow the ma-
terial to expand without tension.
For system documentation, note the positions of the modules and their serial numbers.
Before commissioning, a final inspection of the entire system is recommended.
WARNING
The solar module is a glass product and should be handled with appropriate
care. Do not stand on the solar module. Do not allow any objects to fall or place
any objects on the solar module, as it can cause microcracks in the cells. Never
hold or transport the solar module by the junction box or connection cables. For
installation Solarwatt strongly recommends the usage of clean, fat and silicone
oil free gloves!
WARNING
The solar modules are not designed for concentrated irradiation. Bundling or
concentrating solar irradiation through lenses or mirrors is therefore not permit-
ted and can damage the solar modules.
Solarwatt solar modules fulfill all the requirements of the extended test standard IEC
61215, including the increased pressure load, making them ideal for use in areas with large
amounts of snow. The local regulations or the standard EUROCODE 1 (EN 1991-1) should
be used for the calculation of the snow loads on the module. It is important to note that
these standards are designed for impact on structures and do not explicitly take into
account the installation of solar modules.
Subject to changes | © 2022 Solarwatt GmbH
19

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis