Legrests; Swing-Away Legrests; Adjusting The Legrests; Angle-Adjustable Footplates - B+B Pyro Start Plus Bedienungsanleitung

Pyro Start Plus Pyro Start Plus | Lightweight wheelchair | Lightweight wheelchair
Pyro Start Plus SL Pyro Start Plus SL
| Special sizes | Special sizes

5.2. Legrests

1

5.2.1. Swing-away legrests

2
You can flip the footplates up separately to the side and adjust to the
lower leg length of the user. You can remove the legrests, swing them
away and refit them without needing to use tools.
6.
Attach legrests
• Hold the top of the legrest so that it is pointing outwards.
• Guide the legrest into the hole in the frame using the guide bolts
(Fig. 6).
• Swing the legrest to the front until you hear it clearly click into
place (Fig. 6)
• Flip the footplate down if necessary.
Swing the legrests away and remove them
7.
In order to make it easier to transfer to and from your folding
wheelchair, you can swing the legrests inwards or outwards, without
having to remove them.
• Flip the footplate up if necessary.
2
• Pull the handle upwards (Fig. 7) and swing the legrest outwards
1
(Fig. 8).
• In the outward position, the legrest can be pulled out by pulling it
upwards (Fig. 8).
Before setting off, fit the legrests as described above.
8.
58 58
Never stand on the footplate and when swinging
it away, watch your fingers as there is a risk of
pinching
Lightweight wheelchair | Lightweight wheelchair |
Special sizes | Special sizes |

5.2.2. Adjusting the legrests

Loosen the screws, then adjust the legrest to the required length and
re-tighten the screws (Fig. 9).

5.3. Angle-adjustable footplates

The angle of the footplates can be adjusted:
• Unscrew the hexagon screw at the sprocket (see Fig. 10) Move the
footplate to the required position by rotating the sprocket.
• Re-tighten the sprocket screw (see Fig. 10)

5.3.1. Elevating legrests (optional)

Assemble, disassemble and swing them away as for the standard
legrests.
To adjust, undo the clamp lever, then adjust the legrest to the required
length and then tighten the clamp lever
The horizontal adjustment works as follows:
Upwards
• by lifting the footplate receiver tube you can get the legrest into
the required position.
Downwards
• Pull locking lever upwards
• When doing this, hold the legrest firmly and move to the required
position
• Release locking lever; legrest locks into place automatically.
Never stand on the footplate and when swinging
it away, watch your fingers as there is a risk of
pinching
To change seat, the legrest must be swung away
or removed. Never sit on the legrest. Risk of tipping
over!
Bischoff & Bischoff GmbH |2022-07-20- Revision: 2
Pyro Start Plus Pyro Start Plus
Pyro Start SL Plus Pyro Start SL Plus
9.
10.
59 59