Automatic Programs - Privileg AG034AB6 Gebrauchsanleitung

Page EN-28 Operating modes

Automatic programs

You can prepare dishes with ease thanks to
the 8 automatic program settings. You sim-
ply select the program and enter the weight
of the dish. Automatic mode (see "Automatic
programs table" on page EN-29) does the rest.
Preparation:
1. Remove all packaging and weigh the
dish. The weight is required to ensure the
correct settings.
2. Place the dish in the cooking chamber
and close the door.
3. Ensure that the appliance is in idle state
(normal time display). If a programme set-
ting is still active, press the "Stop/Delete"
button (13).
4. Turn the function selector (15) to the right
to select an automatic program.
To select the automatic program,
you must first turn the function se-
lector (15) to the right. As soon as
the automatic programs are available for se-
lection, turn the function selector (15) to the
left or to the right to make your selection.
5. On the display (11), the name of the auto-
matic program flashes:
A-1
Example (Pizza):
6. To confirm the selected automatic pro-
gram, press the "Start/+30 Sec./Confirm"
button (14).
The name of the automatic program has
stopped flashing.
7. Turn the function selector (15) to select
the weight.
8. Confirm the selected weight by pressing
the "Start/+30 Sec./Confirm" button (14).
The appliance starts. The ventilator starts.
The cooking chamber light will switch on.
The turntable (2) starts to turn. On the dis-
play (11), the pre-programmed time for the
selected dish is counted down, and the in-
dicators for "Microwave" and
matic program" flash.
When the time indicator reaches
signal tones will sound, the appliance will
switch off and the display (11) will now show
the time again.
9. Open the cooking chamber door (8) and
carefully remove the dish or beverage.
With all automatic programs the
cooking time is pre-programmed,
and cannot be extended by press-
ing the "Start/30 Sec./Confirm" button (14).
"Auto-
0:00
, five