Ferm CSM1028 Gebrauchsanweisung Seite 8

GB
• Pull out and tighten the cut depth clamping
knob (16) once the correct depth is set. The
cut depth clamping knob needs to be pulled
out in order to function. Make sure it is
securely tightened before using the machine.
Exchanging or cleaning the saw blade
Fig. A + E + F
• Press the spindle lock button (14) to prevent
the spindle from rotating.
• Loosen the bolt (3) in the centre of the saw
blade, using the wrench key (20).
• Release the spindle lock button (14).
• Turn the safety guard (2) to the rear and hold it
there with the aid of the guard knob (1).
• Remove the retaining ring (4) and the saw
blade. Clean the blade or replace it with a new
one. Make sure the arrow on the saw blade,
indicating the direction of rotation,
corresponds with the direction arrow on the
upper guard.
• Place the saw blade back on the shaft.
• Release the guard knob the allow the safety
guard to return over the saw blade.
• Press the spindle lock. Refit the retaining ring
and firmly tighten the bolt.
Connecting and removing the battery
Fig. G
• Insert the battery into the base of the
appliance, as shown on the illustration. Push
the battery until it latches in.
• Press the locking button (17) before removing
the battery, and disengage the battery from
the base of the appliance.
Only use batteries of the following type.
Using any other batteries could cause
serious injury or damage the tool.
CDA1051: FPB-1800L, 18V Lithium-Ion.
CDA1053: FPB-1800N, 18V NiMH.
The following charger can be used to charge these
batteries.
CDA1052: FPL-1800 (Lithium-Ion and NiMH).
CDA1054: FPL-1800N (NiMH only).
8
4. OPERATION
Wear ear and eye protection.
Switching on and off
• This machine is equipped with a safety switch.
• Start the machine by pressing the "lock off"
button (to disengage the switch) and switch on
the machine.
• Release the (On/Off) switch to switch the
machine off.
Operation
• Hold the work using clamps or a vice to have
both hands free to operate the saw.
• Switch on the saw and place the sole plate on
the workpiece.
• Slowly move the saw towards towards the
previously drawn cutting line and slowly press
the tool forward.
• Firmly press the soleplate on the workpiece
otherwise the circular saw may start to vibrate,
causing the blade to break more easily.
Let the saw do the job. Do not put undue
pressure on the circular saw. If the saw
blade jams in the workpiece, the
machine will automatically switch off.
Laser beamer
Laser beamer in use
The leading beam of the laser beamer makes
sawing in straight lines much easier:
a) along a drawn line, or
b) by aligning it to a fixed point marked on the
workpiece. Press the laser on/off button (8) to
switch the laser on or off.
Adjusting the laser beam
• Transport handling and heavy use can affect
the precision of the laser beam.
• The laser beam itself can be easily adjusted.
• Hold the blade of the circular saw against a
straightedge or perfectly straight plank.
• Switch the laser on.
• Check whether the laser beam runs parallel
along the edge of the straightedge or plank.
Ferm