Using An Extension Cable - DeWalt DW745-LX Originalanweisungen

Your D WALT tool is double insulated in
E
accordance with EN 61029; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.

Using an Extension Cable

If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be
sure the ON/OFF switch is in the OFF
position. An accidental start-up can
cause injury.
Unpacking (fi g. 1, 2)
• Remove the saw from the packaging material
carefully.
• The machine is fully assembled except for the
rip fence and upper blade guard.
• Finalise the assembly following the instructions
as described below.
• Put the push stick (u) on its place at the right-
hand side of the machine (fig. 2).
• Adjust the rear feet (v) until the table (d) is level
in all directions.
• Fully unwind the mains cable.
WARNING:
• Always keep the push stick in its
place when not in use.
• Connect the plug to the mains
outlet only just before starting the
application.
Mounting the saw blade
(fi g. 1– 4)
WARNING: Ensure the machine is
disconnected from the power source.
WARNING: The teeth of a new blade
are very sharp and can be dangerous.
WARNING: The saw blade MUST be
replaced as described in this section.
ONLY use saw blades as specified
under Technical Data. We suggest
DT4226. NEVER fit other saw blades.
• Raise the blade arbor to its maximum by
rotating the control wheel (q) clockwise (fig. 1).
• Place the saw blade onto the spindle in the
order shown in figure 3. The outer flange (z) has
a ø 30 mm raised boss which fits inside the
blade bore. Make sure the teeth point down at
the front of the table.
• Hold the spindle using the open-ended wrench
and tighten the arbor nut (aa) by rotating
clockwise using the arbor wrench (fig. 4).
• To remove the blade, proceed in reverse order.
WARNING: Always check the rip fence
pointer and the riving knife after having
changed the blade.
ENGLISH
37