Bosch rexroth VM350 Betriebsanleitung Seite 26

26/48 Bosch Rexroth AG
General safety instructions
Improper use
Any use of the VM350 power supply module
other than as described in chapter "Intended
use" is considered as improper.
Personnel qualifications
Assembly, commissioning and operation,
disassembly, service (including maintenance and
repair) require basic electrical and mechanical
knowledge, as well as knowledge of the
appropriate technical terms. In order to ensure
operating safety, these activities may therefore
only be carried out by qualified technical
personnel or an instructed person under the
direction and supervision of qualified personnel.
Qualified personnel are those who can recognize
possible hazards and institute the appropriate
safety measures due to their professional
training, knowledge, and experience as well as
their understanding of the relevant conditions
pertaining to the work to be done. Qualified
personnel must observe the rules relevant to the
subject area.
Representation of information
In order to enable you to work with your product
in a fast and safe way, uniform safety
instructions, symbols, terms and abbreviations
are used. For a better understanding, they are
explained in the following sections.
VM350 | 3609929B32/2021-09
Safety instructions
In this documentation, there are safety
instructions preceding a sequence whenever
there is a risk of personal injury or damage to
equipment. The hazard avoidance measures
described must be observed.
Safety instructions are structured as follows:
SIGNAL WORD
Type of risk
What occurs when the safety instructions
are not complied with
Hazard avoidance

Safety sign: alerts the user to the risk
•
Signal word: identifies the degree of the risk,
•
see Tab. 1 on page 27
Type of risk: identifies the type or source of
•
the risk
Consequences: describes what occurs when
•
the safety instructions are not complied with
Precautions: states how the hazard can be
•
avoided