Clean oil burner combustion chamber
Tool required: Screwdriver (Phillips), Allen® key (3 mm, 5 mm), double-ended spanner (10 mm),
long socket (10 mm), cordless screwdriver, tool for TEHA oil burner, brushes.
Original operating manual for oil-fired pasteurizers EHA40, EHA66, EHA90
16.02.2021
-
-
-
-
ATTENTION
During reassembly, pay attention to the photo sensor orientation (sight glass
down). Only slightly tighten the fixing screw.
Take off the upper panel of the burner module casing
(5).
Remove the burner exhaust pipe (4).
Pull the ignition electrode plug out of the ignition
electrode.
Loosen the fixing screw on the flame monitoring photo
sensor and remove the photo sensor.
Maintenance
69 of 147
English