The Metronome - Korg EC150 Bedienungsanleitung

Soft pedal. The sound will be softer and more mellow while you press the pedal.
The depth at which you press the pedal will adjust the softness of the sound (half-
pedal effect).
Damper pedal settings for Layer.
apply the damper pedals to.
Hold the TRANSPOSE/FUNCTION button, and press the damper pedal. Each time
1
you press the pedal, the LED on the sound selection button(s) where the damper
pedal is active will light.
When the pedal is assigned to the desired sound(s), release the TRANSPOSE/
2
FUNCTION button.
Note: When the instrument is turned on, the pedal settings are reset. To save these
settings, save them using the Data Dump function (see "MIDI Data Dump" on
page 35).

The metronome

The EC150 incorporates a metronome, with which you can set the tempo during
practice.
Starting and stopping the metronome.
make the metronome start or stop. When turning on, the metronome is set according
to the slider position, but you can adjust it with the procedure described below. After
having listened to the demo, the tempo will be that of the last demo that had been
listened to.
Adjusting the metronome volume.
METRONOME button pressed and repeatedly press the STRINGS/PAD button (or
the B5 key) to lower the volume, or the CHOIR button (or the C6 key) to raise it. To
reset the volume, simultaneously press the STRINGS/PAD and CHOIR buttons (or
the B5 and C6 keys on the keyboard) while holding the METRONOME button.
Key
B5
Adjusting the tempo using the TEMPO slider.
the tempo. The range is = 40 ~ 200.
20
Effect
Lower volume
In Layer mode, you can select the sound(s) to
Press the METRONOME button to
While the metronome is playing, keep the
Key
C6
Use the TEMPO slider to adjust
Effect
Higher volume
Chapter 3