Control Change - Korg EC150 Bedienungsanleitung

Program Change enable/disable.
must enable Program Change messages transmission and reception. Otherwise, you
can disable Program Changes data.
Hold down the TRANSPOSE/FUNCTION button, and press the PIANO 2 sound
selection button. Each time you press the switch, the setting will alternate between
Enabled and Disabled.
Program Change status
Enable
Cancel
Note: When the power is turned on, program changes will be enabled for all MIDI
channels.

Control Change

When you operate the damper pedal, adjust the balance in Layer mode, or make
other adjustments on the control panel, a Control Change message is sent to a con-
nected external MIDI device. At the same time, EC150 can receive a Control
Change message from an external MIDI device connected to its MIDI IN, to control
the damper pedal, volume adjustment, and other data.
Control Change enable/disable.
must enable Control Change messages transmission and reception. Otherwise, you
can disable Control Changes data.
Hold down the TRANSPOSE/FUNCTION button, and press the E.PIANO 1 sound
selection button. Each time you press this button, the setting will alternate between
Enabled and Disabled.
Control Change status
Enabled
Disabled
Note: When the power is turned on, Control Change messages will be enabled on
all MIDI channels.
34
To transmit and receive this kind of data, you
PIANO 2 LED status
Lit
Dark
To transmit and receive this kind of data, you
E.PIANO 1 LED status
Lit
Dark
Chapter 6