Inhaltsverzeichnis
Werbung
TIRE PRESSURE CHECK
4. To stiffen the spring preload, install the
circlip 1 into the groove a. To soften the
spring preload, install the circlip into the
groove b.
NOTE:
Do not spread the circlip too much.
Standard installation position:
Groove b
5. Install:
Spring guide 1
G
NOTE:
While compressing the spring, install the
spring guide.
6. Install:
Rear shock absorber
G
Refer to "SWINGARM" section in the
CHAPTER 5.
EC36Q000
TIRE PRESSURE CHECK
1. Measure:
Tire pressure
G
Out of specification → Adjust.
Standard tire pressure:
100 kPa (1.00 kgf/cm
NOTE:
Check the tire while it is cold.
G
Loose bead stoppers allow the tire to slip off
G
its position on the rim when the tire pressure
is low.
A tilted tire valve stem indicates that the tire
G
slips off its position on the rim.
If the tire valve stem is found tilted, the tire is
G
considered to be slipping off its position. Cor-
rect the tire position.
3 - 14
INSP
ADJ
2
, 14.5 psi)
Werbung
Inhaltsverzeichnis
