Operation - Husqvarna BG 250 Bedienungsanweisung

by the manufacturer, can cause serious injury or
death.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Use personal protective equipment. Refer to
Personal protective equipment on page 37 .
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
schedule on page 48 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Put the product on the work area. Make sure that the
surface is level. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
7. Make sure that there are diamond tools on the
grinding head and that they are tightly attached.
8. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 42 .
9. BG 250: Connect the product to a power source.
To connect the product to a power source
Refer to
BG 250 on page 42 .
10. BG 250Petrol: Fill the fuel tank. Refer to
BG 250Petrol on page 42 .
11. BG 250Petrol: Do a check of the oil level. Refer to
To do a check of the oil level (BG 250Petrol) on
page 50 .
12. BG 250: Make sure that you know the direction of
rotation of the motor. Refer to
direction of rotation of the motor BG 250 on page
45 .
Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
1802 - 002 - 13.04.2022
Before you operate the
Maintenance
Transportation on page 54 .
To fill fuel
To do a check of the
• Let an approved service agent do servicing on the
product regularly.

Operation

To replace the grinding disc
WARNING:
disconnect the power plug before you
replace the grinding disc, to prevent
accidental start.
WARNING:
grinding disc can become very hot.
WARNING:
protection when you replace the grinding
disc. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the grinding disc. The
dust extractor will decrease the dust that can
cause health problems.
CAUTION:
always have the same number and type of
diamond tool segments. The height of the
To
diamond tool segments must be the same
on all grinding discs.
1. Stop the product and for BG 250 disconnect the
power plug.
2. Hold the handlebar and tilt the product rearward. Tilt
the product until the handlebar is on the floor.
For BG 250, always
Use protective gloves, as
Use approved respiratory
Use the dust extractor
All the grinding discs must
WARNING:
Make sure that the
product is in a stable position before you
replace the grinding disc.
41